Advertisement
Quick Links
Advertisement
Related Manuals for Goscam GB8209
Summary of Contents for Goscam GB8209
-
Page 2: Table Of Contents
Contents 1. Packing List 2. Diagram 3. Structure 4. Installation 5. Specification 6. FCC and EU... -
Page 3: Packing List
1. Packing List Sensor for camera * 8209AW means GB8209 + GB7609 2. Diagram... -
Page 4: Structure
3. Structure 3-1. Structure of Camera Antenna Alarm IR LEDs Switch Power Lens On/Off Sensitivity Switch Power Channel Socket Battery Switch Cover Sensor Socket 3-2. Structure of Receiver Battery Antenna Cover AV Out Power Socket TFT-LCD Channel Indicator Sleep Button Channel Volume Button... -
Page 5: Installation
4. Installation 4-1. Installation of Camera 4-1-1. Basic installation of Camera 2. Connect the camera to the adapter and then slide the power switch to ON position. Note: This camera can also use dry battery as power supply. Please load 4 AA batteries to the battery compartment at the back of camera with their polarities matched. - Page 6 3. Rotate the rounded head of camera to a suitable angle for surveillance. 4-1-2. Camera channel setup 1. Check out the right side of the camera and there is the channel switch marked as CH1, CH2, CH3, CH4. Each of them can be selected separately for the purpose of the multi-camera working situation or interference avoidance.
- Page 7 2. Connect the sensor jack to the camera sensor socket, put the sensor end in cotton diaper if you select the Bed-wetting Sensor detection. * Specialists recommend the sensor is not suitable for disposable panty diaper; and not suitable for touching skin directly.
- Page 8 4-2. Installation of Receiver 4-2-1. Basic installation of Receiver 1. Connect the receiver to the adapter and then slide the power switch to ON position. Note: This receiver can also work on dry battery. Please load 4 AA batteries to the battery compartment at the back of receiver with their polarities matched.
- Page 9 3. Set the channel of receiver to be the same as camera by pressing the channel button continuously, and the pictures will display on the screen. Note: For more clear pictures, please connect the receiver to a monitor/TV with AV cable (yellow for video and red for audio). AV cable 4-2-2.
-
Page 10: Specification
5. Specification Item Value ISM 2,400~2,483 MHz Transmission Frequency Transmission Power 10mW/CE; 2mW/FCC Operating Frequency 2,414MHz; 2,432MHz; 2,450MHz; 2,468MHz Unobstructed Effective Range 100m(Min.) Modulation Mode ~ +50 / +14 ~ +122 Operating Temperature Operating Humidity Imaging Sensor Type CMOS PAL: 720 480Pixels;... -
Page 11: Fcc And Eu
6. FCC information This device complies with part15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. - Page 12 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user’s authority to operate the equipment. Any change to the equipment will void FCC grant. This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules.
Need help?
Do you have a question about the GB8209 and is the answer not in the manual?
Questions and answers