Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Billion MD1000
- Page 1 Billion ZigBee Module User Manual (MD1000)
- Page 2 DESCRIPTION The MD1000 module is a ZigBee™ network solution that integrates a 2.4Ghz, IEEE ® 802.15.4-compliant transceiver with a 32 bit ARM Cortex M3microprocessor. It contains integrated Flash and RAM memory and peripherals of use to designers of ZigBee-based applications.
-
Page 3: General Features
GENERAL FEATURES Ember™ EM357 platform 192KB Flash memory, with option read protection 12KB SRAM ® 32-bit ARM Cortex M3 microprocessor 24 general purpose I/O ports DMA-SPI, I2C and UART interfaces Integrated 12-bit resolution ADC ... -
Page 4: I/O Pin Assignment
RX Sensitivity Typical -100dBm(-101dBm in Boost mode) at 1% packet error rate Operating Temperature (Ambient) -40 °C ~ +85 °C Humidity (Non-condensing) 0~95% RH I/O PIN ASSIGNMENT Pin # Name Direction Description Ground Ground No connection Ground Ground Ground Ground Ground Ground No connection... - Page 5 ZigBee WPS input Power 3.3V power supply input Internal Antenna: ANT_0 = High, ANT_1 = Low input (default) ANT_0 External Antenna: ANT_0 = Low, ANT_1 = High input Pin # Name Direction Description Internal Antenna: ANT_0 = High, ANT_1 = Low input (default) ANT_1 External Antenna: ANT_0 = Low, ANT_1 = High input Ground...
-
Page 6: Electrical Characteristics
ELECTRICAL CHARACTERISTICS Absolute Maximum Ratings Parameter Min. Typ. Max. Unit Power supply voltage -0.3 Voltage on any digital pin -0.3 VCC + 0.3 Max 3.6 Operation temperature range °C Storage temperature range °C Note: Exceeding the maximum ratings may cause permanent damage to the module or devices. Operating Conditions Parameter Min. - Page 7 DC Characteristics Parameter Min. Typ. Max. Unit Active Current (TX) TX, Normal Mode, +3 dBm TX, Boost Mode, +8 dBm TX, Normal Mode, 0 dBm 28.5 Active Current (RX) RX, Normal Mode, +3 dBm RX, Boost Mode, +8 dBm summarizes the DC characteristics at 25°C and VDD of 3V of the EM35x Module. RF Characteristics (@25°C, VCC=3.3V) Parameter Min.
- Page 9 PCB COPPER PATTERN LAYOUT...
- Page 10 DIMENSIONS...
- Page 11 Placement Guideline It is recommended that MD1000 be placed on the corner of the main board and near the edge as shown below.
- Page 12 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the MD1000 and is the answer not in the manual?
Questions and answers