Mounting - Atmor thermoboost series Installation And Operation Manual

Mounting

01
The mounting surface
must be solid and secure.
03
Make sure the unit is
level prior to securing the
mounting screws.
06
The water heater must be installed in a manner that prevents
contact with combustible materials. Keep combustible materials at
least two feet away from the heater and hot water output pipe.
The water heater and hot water outlet pipe must be securely out of
the reach of children to prevent tampering with controls or contact
with an extremely hot pipe.
07
If installing the heater on an upper floor or in an attic, be sure
installation is in compliance with local code. Install a drip pan
with drainage, or a leak detector and automatic shutoff valve, to
prevent damage in case of a leak.
5
04
The unit must be installed
in an upright position with
the water inlet and outlet
at the bottom.
02
Use mounting screws
that are at least 1 inch
in length.
05
Do not install the unit
above electrical boxes
or junctions.