Chapter 1 Introduction System Requirements This chapter describes the package contents, PC Card description, system Installation of the PC Card requires: requirements, features & benefits, applications and network configurations 1. PC/AT compatible computer with PCMCIA Type II slot. of our wireless LAN products. 2.
Infrastructure Mode The infrastructure mode requires the use of an access point (AP). In this Chapter 2 Installing Driver & Client Utility mode, all wireless communications between two computers have to be via This chapter describes how to install the PC Card drivers and client utility the AP no matter the AP is wired to Ethernet network or stand-alone.
Page 4
Figure 2-2 5. Review the “License Agreement” then press Next as shown in Figure Figure 2-4 2-3. 7. The program will automatically proceed with installing as shown in Figure 2-5. Figure 2-3 6. Press Install to begin the installation as shown in Figure 2-4. Figure 2-5 8.
1. Click the Start button, and then click Control Panel. 2. In the Control Panel window, double-click the System icon, then select the Device Manager tab from Hardware page. 3. Double-click Network adapters, then select SendFar IPN2120 Wireless LAN Card as shown in Figure 2-6. Note 1.
Installation for Windows 98SE/ME/2000 Installation for Windows 98SE/ME/2000 are all the same with Installation for Windows XP. Before plug WPC-3110 into the PCMCIA slot, you must install the driver and utility at first. So please refer the Windows XP installation procedures to install the driver and utility for your PC or Notebook which installed with Windows 98SE/ME/2000.
Status Encryption A typical screen of the application in Infrastructure mode is shown in By choosing this option, you can set the card with its encryption mode to Figure 2-7. The Network Address section shows the current Network NONE or WEP, the authentication mode to Open system or Shared key or status such as the MAC address, Subnet Mask address, Gateway address Auto Switch.
Page 8
This panel allows the entry of keys or pass phrase, which can then be written to the driver and registry. Note that each key must consist of hex digits, it means that only digit 0-9 and letters A-F are valid entries. If entered incorrectly, program will not write keys to a driver.
3. On the Hardware tab, choose Device Manager, and click Network Verify that the PC Card is properly inserted into Adapter. Choose SendFar IPN2120 Wireless LAN Card and remove it. the PC Card slot. 4. After removing the SendFar IPN2120 Wireless LAN Card, restart your computer.
Europe, 2 for Spain, 4 for France antenna slightly. RF Output Power 20dBm (WPC-3110) If necessary, move your notebook computer a Sensitivity @ THP≧3Mbps 11 Mbps <-83dBm (WPC-3110), few inches to find a better signal. Use the Link Quality and Signal Strength display Environmental in the Client Utility to determine the best Temperature Range 0 to 55℃...
Chapter 5 Regulatory Compliance Information Radio Frequency Interference Requirements This device complies with Part 15 of FCC Rules and Canada RSS-210. Operation is subject to the following conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the WPC-3110 and is the answer not in the manual?
Questions and answers