Related Manuals for RadioPopper JRX
Summary of Contents for RadioPopper JRX
- Page 1 RadioPopper JrX Radio Wireless Owners Manual...
- Page 2 RadioPopper is owned and manufactured by Leap Devices, LLC in Phoenix Arizona. This product was designed, produced, and manufactured in the USA. FCC STATEMENT This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
-
Page 3: Table Of Contents
Limited Warranty ..........JrX Transmitter Firmware Version 1-01 JrX Receiver Firmware Version 1-01 RadioPopper JrX User Manual - Rev 1.01 Page 3... -
Page 4: Introduction
The RadioPopper JrX system is a high quality and highly reliable radio triggering system. The JrX provides long range triggering of lighting equipment, as well as integration and compatibility with RadioPopper JrX units. - Page 5 Introduction Page 5...
-
Page 6: Specifications
RadioPopper JrX Radio Wireless System Compatible Hardware: The JrX System has been tested and found to be compatible with the following flash hardware. See our website for updates as we test and certify compatibility with additional hardware. Transmitter: May be used with any camera with a standard hotshoe mount. May also be used via an external PC Sync cable ap- propriate to your particular brand of camera. -
Page 7: Specifications And Warnings
USE ONLY THE SUPPLIED TRANSMITTER ANTENNA! Using any antenna other than the one supplied for use with your JrX Transmitter is a violation of Federal Law and may actually cause damage to the radio inside the transmitter. This will also promptly void your warranty. Your JrX Transmitter has been carefully tuned to broadcast the maximum signal strength allowable by law. - Page 8 RadioPopper JrX Radio Wireless System Page 8...
-
Page 9: Parts Descriptions
Parts Description Page 9... - Page 10 JrX Transmitter will activate and broadcast a trigger signal each time you activate your camera’s shutter. You may optionally connect a sync cord to the sync port provided on the side of the JrX Transmitter.
-
Page 11: Installation
JrX Receiver. NOTE: The Data Port connector is only enabled in the “Studio” version of the JrX Receiver. This port is NOT enabled in the “Basic” version of the JrX Receiver. For more information about the use of the Data Port to control compatible studio lights, please refer to the section on page 12. -
Page 12: Option Switch Operation
JrX Receiver and the two units will be on the same channel and should operate together. You may want to dial in a specific channel to allow a JrX Transmitter to trigger a PX Receiver, or to allow a JrX Receiver to be triggered by a PX Transmitter. - Page 13 Installation Page 13...
- Page 14 RadioPopper JrX Radio Wireless System Canon is a registered trademark of Canon Inc. in the United States and may also be a registered trademark ortrademark in other countries. ITTL stands for Intelligent Through The Lens, the trade-marked name for Nikon’s exposure measurement system on SLR cameras. Nikon is a registered trademark of Nikon Corporation.
-
Page 15: Limited Warranty
LIMITED WARRANTY The Limited Warranty set forth below is given by Leap Devices LLC (hereafter “Leap”) in the United States with respect to the RadioPopper JrX Transmitter and / or RadioPopper JrX Receiver packaged with this Limited Warranty and identified by model number within this Limited Warranty (each a “Product”) when purchased and used in the United States or in Canada. - Page 16 Copyright 2007-2009, Leap Devices LLC, All Rights Reserved...
Need help?
Do you have a question about the JRX and is the answer not in the manual?
Questions and answers