Summary of Contents for Innovative Dehumidifier Systems IW-25-2
Page 1
IW-25-1 Dehumidifier Please Read and Save These Instructions Please Read and Save These Instructions Please Read and Save These Instructions Innovative Dehumidifier Systems, LLC Innovative Dehumidifier Systems, LLC Innovative Dehumidifier Systems, LLC 6260 Ocean Highway 17 West 6260 Ocean Highway 17 West...
(as required for all electrical appliances). If non-grounded wiring is used, all liability re- verts to owner and the warranty is voided. • The IW-25-2 Dehumidifier should only be installed and serviced by a qualified technician. • If there is a chance that water flooded the dehumidifier, it should be opened and allowed to dry thoroughly before reconnecting to electrical power and restarting.
4. Do not use a plug adapter. Principle of Operation The IW-25-2 Dehumidifier utilizes its integral humidistat to monitor the conditioned space. When the relative humidity goes above the selected set point, the dehumidifier will energize. Air is drawn across an evaporator coil, which is cooler than the dew point of air. This means moisture will condense out of the air.
Do not install your dehumidifier in a corrosive environment. Mounting: The IW-25-2 Dehumidifier is designed to mount into the wall cavity between two studs mounted on standard 16” centers. The chasis of the unit slips into the wall from the front and is secured by the four mounting tabs with screws (not provided).
The humidity can be set in increments from 30-90%. Pressing the SET button increases the setpoint by 5% unit you reach and then it sequence back to 30% and increases from there. IW-25-2 Dehumidifier Diagram Unit Overview • Front View •...
Back View Rear View Chassis Mounting Flanges – Typ 4 Power Cord Drain Hose Connection Electrical Cover Plate Maintenance 5.2.3 Filter Installation 5.Maintenance When installing the filter to the WARNING: 115 Volts AC may cause seri- WARNING back of the cover, insert in tabs on : 120 Volts AC may cause serious injury from electric shock.
Page 8
5.2.1.Removing the Filter operate with all components shown. Do not remove any parts including Remove the screws in the front Styrofoam fan shroud. cover and then push the front cover up gently to free the cover hooks from chassis. Filter is located on the back side of Front cover.
Troubleshooting Symptom Cause Solution Power Supply Verify that there is power to the outlet and that the plug is properly installed in outlet Room Temperature Over 90° The unit is outside the operating Machine Won’t Run Machine Won’t Run Below 50° temperature range.
Innovative Dehumidifier Systems, LLC (IDS) warrants the equipment to be free from defects in workman- Innovative Dehumidifier Systems, LLC (IDS) warrants the equipment to be free from defects in workmanship and ship and materials for a period of 24 months after shipment. This warranty is limited, however, to the re- materials for a period of 24 months after shipment.
Need help?
Do you have a question about the IW-25-2 and is the answer not in the manual?
Questions and answers