Ectaco SpeechGuard TLX User Manual page 9

®
ECTACO SpeechGuard

Open the antenna cover.

Screw the antenna on the connector.
Setting up Parameters

Launch the 2 Way Radio application.

Select the check box in the top row to enable country selection.

Tap the Area button and select your country or region.

Tap the CH button and select a channel.

Tap the CTCSS button and select one of the available levels. For example,
select 0.

Tap the SQ button and select a noise cancelation level. It is recommended
that you select 1.

Tap the OK button to save settings.
Note: Make sure the device of your interlocutor has the same 2 Way Radio
settings. To communicate, all radios in your group must be set to the same
channel and CTCSS code.

Tap the Power On button to turn the radio on.
You can also configure the 2-Way Radio manually. To do this, select the check
box in the second row and then enter the frequency value manually. Below is an
example of settings.

Set TFV and RFV frequencies to 462.7 MHz or any other frequency allowed
for this purpose in the host country.

Set RX-CT to 0.

Set SQ to 1.

Tap the OK button to save settings.
Talking and Listening

To talk, press and hold the Push-to-Talk button (see General View on page 6).

To listen, release the Push-to-Talk button. Use the Volume Up and Volume
Down buttons to adjust the volume.

When you have finished using the 2-Way Radio function, tap the Power Off
button.
®
TLX
9
User Manual