Related Manuals for Vidao VSB2500
Summary of Contents for Vidao VSB2500
- Page 1 2.0CH SOUNDBAR MODEL: VSB2500 FOR TECHNICAL ASSISTANCE & TROUBLESHOOTING PLEASE CALL 1-855-998-4326 OR VISIT WWW.SIBRANDSSUPPORT.COM...
- Page 2 RF Exposure The equipment has been evaluated to meet general RF exposure requirement. The device can be used without restriction.
-
Page 3: Location Of Controls
LOCATION OF CONTROLS 1. STEREO RCA Audio Inputs 2. OPTICAL Input 3. DC Power Input 4. POWER: Press and hold 2 seconds to turn the unit ON or OFF. / SOURCE: Press and release to select the inputs: BT, Aux in, Line in or Optical in. 5. - Page 4 REMOTE CONTROL – LOCATION OF CONTROLS 1. POWER: Press to turn the unit ON or OFF 2. BT: Press to switch to Bluetooth Mode. 3. AUX: Press to switch to AUX Mode. 4. MUSIC: Press to switch to the EQ setting optimized for music. 5.
- Page 5 REMOTE CONTROL BATTERY INSTALLATION The remote control operates on one CR2025 battery (included). To activate the remote control, remove the insulation tab inserted in the battery compartment. To remove the tab, pull it in the direction of the arrow in the illustration as shown. When the operation of the remote control becomes intermittent or unsatisfactory, replace the original battery with a new 3-volt lithium battery.
-
Page 6: Led Indicator Lights
POWER 1. Plug the supplied AC Power Cord into the DC Power Input (3) on the rear of the unit 2. Insert the wall plug of the AC Power Cord into an electrical wall outlet. LED INDICATOR LIGHTS This Soundbar has 5 Colored LED Indicator Lights on the front of the unit. These lights will show the current •... -
Page 7: Using The Stereo Rca Inputs
USING THE STEREO RCA INPUTS When connecting two products using an RCA cable, match the colored ports with the same colored connection. Before use, disconnect any cables connected to the LINE IN input (6). 1. Connect the RCA Cable to the STEREO RCA Audio Inputs (1) located on the back of the Soundbar, and to the audio outputs on the Television or other A/V component. -
Page 8: Using The Line In
LED Indicator light will begin flashing BLUE. When pairing a device, remain within 3 feet of the Soundbar. 4. Enter the Bluetooth menu on your Bluetooth device, and select the “VSB2500” in your available Bluetooth Devices List to pair your device to the Soundbar. -
Page 9: Troubleshooting Guide
TROUBLESHOOTING GUIDE Problem What to do No power Check the connection of the AC/DC adapter between the Soundbar and wall outlet. Check that the volume control is not at minimum No sound Check that the Soundbar & Connected Device are not set to Mute. - Page 10 Televisions, DVD Players, etc. are not covered nor is the cost incurred in shipping the unit for warranty repair or exchange. Under no circumstances shall VIDAO be liable for any loss (direct, indirect, incidental, foreseen, unforeseen, special or consequential) or for any damage arising out of, or in connection with, the use of this product.
- Page 12 ©Schoenfeld International Inc., 2017 VSB2500 Rev. 1.0 August 2017...
Need help?
Do you have a question about the VSB2500 and is the answer not in the manual?
Questions and answers