SAFETY PRECAUTIONS Contents WARNING This product contains a chemical known to the State of California to cause SAFETY PRECAUTIONS -----------------------------------2 cancer or birth defects or other reproductive harm. BACK-UP CAMERA SAFETY -------------------------------2 This safety alert symbol indicates that a potential personal injury hazard is present.
regulations and ensure compliance. FEATURES When installing the Back-Up Camera, the vehicle must be turned off with the vehicle in park and the park brake applied. Do not attempt to install the Back-Up Camera while the engine is operating. Color monitor display image gotten from the rear of the vehicle. Do not modify the wiring in any way.
NOTICE Installation The camera should be mounted to a horizontal position relative to the ground. NOTICE (2).Lose the screws on the camera’s bottom, so as to pitch the camera to a Some states or local governments may have regulations or laws that desired angle.
Page 5
(8).Remove the vehicle’s negative (-) battery cable. (1 1).Using the electrical tape to fix the wire you are splicing into the vehicle. (9).Once the proper wires for the reverse lights have been determined, the (12).Run the Back-Up Camera’s cables as the picture shown below. camera wires must be spliced into the vehicle wires.
(14).The monitor can be adjusted to a desired angle. (16).When you reverse your vehicle, it will activate the monitor automatically and offer a rear view for parking as assist. NOTE: The monitor will remined off until the reverse light is triggered. Overview (15).Connect the monitor’s power cables and insert the car charger into the cigarette lighter’s socket.
Tint Settings Press the“ Up”button to increase the value and press“ down”button to decrease the value. Language Setting Mode The language by default is English. Press the menu button 6 times then the To select a screen ratio, 16:9. language setting will pop up. Press Up or Down button to select a preferred language.
Need help?
Do you have a question about the C53 and is the answer not in the manual?
Questions and answers