Do you have a question about the Baby Bouncer and is the answer not in the manual?
Questions and answers
Summary of Contents for Baby wise Baby Bouncer
Page 1
Baby Bouncer INSTRUCTION MANUAL Complies with EN12790:2009 and AS/NZS ISO 8124-2:2009, 8124-3:2012 IMPORTANT: Thank you for choosing our product. Please read and understand these instructions before using this baby bouncer. If in doubt, please seek help from our Customer Service Team.
Page 2
DO NOT use if any parts are missing, damaged, or broken. This baby bouncer does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
PARTS LIST Please retain all packaging until after assembly is complete and you are certain no parts are missing. After assembly, please dispose of all packaging carefully. Rear Bar Left Side Spring Right Side Spring Left Upper Tube Right Upper Tube Lower Tube Seat Cover &...
Page 4
ASSEMBLING THE BOUNCER Fit the two Side Springs to the Rear Bar – fold out the plastic Corner and align the Side Spring and Rear Bar ends, then snap the plastic Corner back into place to hold them together – see inset picture. Note that the open face of the plastic Corner must be facing upwards when the Bouncer is fully assembled.
Page 5
Click the Lower Tube into the plastic Connectors on the Upper Tubes. Ensure the spring buttons click positively into place. Give the Tubes a good pull to ensure they are locked in place. Place the Tube assembly onto the leg assembly by sliding the ends of the Left and Right Springs into the holes in the plastic connectors, below the Lower Tube.
Page 6
FITTING SEAT COVER AND HARNESS Pull the Seat Cover and Harness over the top of the Upper Tubes so that they are fully inserted into the pocket on the back of the cover. Turn the Bouncer over so that the Cover and Tubes are resting on the table and buckle on the cover.
Page 7
Slide the feet into position on the two Side Springs. They should be under the spring and just at the front bend. These feet, and the two rear plastic corners must be in the correct position to prevent the Bouncer from sliding on the floor. USING THE BOUNCER With the Bouncer on a firm level floor surface, unbuckle the harness.
Place baby in the Bouncer with the harness straps pulled out from behind, lift up the flap between the legs, and buckle the harness up. Check buckles have fastened properly by tugging on them. Adjust the side straps as required to hold baby firmly in place.
Need help?
Do you have a question about the Baby Bouncer and is the answer not in the manual?
Questions and answers