Planon Printstik PS900 Series User Manual page 24

Thermal label printer
Hide thumbs Also See for Printstik PS900 Series:
Table of Contents

Advertisement

FCC Regulations:
Radio Frequency related information
CE:
The equipment has been tested and found to comply with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
The Declaration of Conformity related to this product, and other compliance
matters can be obtained by sending a request to compliance@datawind.com
FCC:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
This device complies with the part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures: A) Reorient or relocate the receiving antenna.
B) Increase the separation between the equipment and receiver.
C) Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. D) Consult the dealer or an experienced technician for
help.
Caution: Changes or modifications to this equipment not expressly approved by
Datawind for the compliance could void the user's authority to operate this
equipment.
The antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be collocated or
operating in conjunction with any other antenna or transmitter.
24

Advertisement

Table of Contents
loading

Related Products for Planon Printstik PS900 Series

Table of Contents