Table of Contents
Advertisement
Quick Links
Installer Guide
7490 Wireless Remote Outdoor Sensor
Please read all instructions before proceeding.
The wireless remote outdoor sensor monitors temperature at a remote outdoor
location and transmits the temperature data wirelessly to the thermostat. The
sensor can be used to view the outdoor temperature or for heat pump systems
requiring the use of balance points. One wireless outdoor remote sensor can
be connected.
1 Specifications
Operating Temperature: 40 - 120 ˚F
Storage Temperature: 40 - 120 ˚F
Operating Humidity: 5 - 95% Rh
Blue LED Indicator
- 1 flash every 30 seconds:
- 3 flashes every 30 seconds: Sending sensor data to thermostat
- 1 flash every 2 seconds:
- Solid for 60 seconds:
Red LED Indicator
- 3 flashes every 30 seconds: Low battery
- 1 flash every 10 seconds:
NOTE: LED indicators are only visible with the sensor cover off.
IMPORTANT: Before mounting the remote sensor, you should verify there is good
wireless communication in the area you wish to mount it by first pairing it in that
location. If you are having trouble pairing in that location, try moving the remote
sensor to a location closer to the thermostat.
®
smart connect
Battery Power: 3.0 Volt DC
Accuracy: +/- 1˚F
Normal operation
Sensor is in pairing mode
Successfully paired remote sensor
Lost communication with thermostat
7490-100-02
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Braeburn 7490
Summary of Contents for Braeburn 7490
-
Page 1: Installer Guide
® Installer Guide smart connect 7490 Wireless Remote Outdoor Sensor Please read all instructions before proceeding. The wireless remote outdoor sensor monitors temperature at a remote outdoor location and transmits the temperature data wirelessly to the thermostat. The sensor can be used to view the outdoor temperature or for heat pump systems requiring the use of balance points. - Page 2 2 Pairing Remote Sensor See thermostat Installer Guide for additional information on pairing sensors. 1. Enter the wireless setup mode on the thermostat you wish to pair with the remote sensor. Proceed until you see the word SENS in the display with a flashing symbol.
- Page 3 3 Installation 1. Place the small bracket against the wall in the desired location and mark placement of the two mounting holes. Remove bracket and carefully drill your marked areas with a 3/16” drill bit. 2. If needed, gently tap supplied plastic anchors into the holes in the wall and fasten the bracket to the wall using the two supplied screws.
- Page 4 4 Replacing a Thermostat or a Sensor Replacing a Thermostat – If you are replacing a thermostat that is paired with an existing wireless sensor, you will need to clear the remote sensor and pair it again with the newly installed thermostat. 1.
- Page 5 MPEG LA License Agreement THIS PRODUCT IS LICENSED UNDER THE WIRELESS NETWORK PATENT PORTFOLIO LICENSE FOR USE BY A CONSUMER OR OTHER USES FOR WHICH THERE IS NO REMUNERATION. ANY OTHER USE OF THIS PRODUCT IN ANY MANNER IS NOT LICENSED AND IS EXPRESSLY PROHIBITED WITHOUT A LICENSE UNDER APPLICABLE PATENTS IN THE WIRELESS NETWORK PATENT PORTFOLIO, WHICH LICENSE IS AVAILABLE FROM MPEG LA, LLC, 4600 S.
- Page 6 When installed by a professional contractor, this product is backed by a 5 year limited warranty. Limitations apply. For limitations, terms and conditions, you may obtain a full copy of this warranty: YEAR · Visit us online: www.braeburnonline.com/warranty · Write us: Braeburn Systems LLC LIMITED WARRANTY 2215 Cornell Avenue Montgomery, IL 60538 ®...
Need help?
Do you have a question about the 7490 and is the answer not in the manual?
Questions and answers