Peak Cut Mode - Fujitsu AB*G45LRTA series Design & Technical Manual

14-2-2.

PEAK CUT MODE

LED lamp part
SW2
SW1
(1) Switch to "Local setting mode" by pressing [MODE] button (SW1) for 3 seconds or more.
(2) Confirm that the (POWER / MODE) blinks 9 times, then press [ENTER] button (SW3).
PUMP
POWER
LOW NOISE
DOWN
ERROR
MODE
(L1) (L2)
Blinks
(9 times)
Sign " " : Lights off
(3) Press [SELECT] button (SW2), and adjust LED lamp as shown below. (Current setting is
displayed)
LOW NOISE
(L2)
PEAK CUT
Blink
MODE
(4) Press [ENTER] button (SW3).
LOW NOISE
(L2)
PEAK CUT
MODE
Sign "
(5) Press [SELECT] button (SW2), and adjust LED lamp as shown in below figure.
0% of rated input ratio
50% of rated input ratio
75% of rated input ratio
100% of rated input ratio
(6) Press [ENTER] button (SW3) to fix it.
0% of rated input ratio
50% of rated input ratio
75% of rated input ratio
100% of rated input ratio
(7) Return to "Operating status display (Normal operation)" by pressing [EXIT] button (SW4).
• To restart the setting during the process, return to "Operating status display (Normal operation)" by pressing the
[EXIT] button once.
SW3 SW4 SW5
PEAK CUT
(L3) (L4) (L5) (L6)
(L3)
(L3)
" : Lights on
PEAK CUT
(L4) (L5) (L6)
Blink
Blink
Blink Blink
Blink
PEAK CUT
(L4) (L5) (L6)
- (02 - 23) -