Philips EXP320 Service Manual page 5

INSTRUCTION FOR USE
GENERAL INFORMATION / POWER SUPPLY
Supported formats
This set supports:
– Disc format: ISO 9660, Joliet, Multisession, UDF, Enhanced Music CD,
Mixed Mode CD
– MP3 bit rate: 32–320 kbps and variable bit rate
–Total number of music files and albums : around 400
All trademarks used are owned by their respective owners.
Batteries (supplied or optionally available)
Inserting batteries
• Open the battery compartment and insert either
2 normal or alkaline batteries type AA (LR6, UM3).
Old and new or different types of batteries should
not be combined.
Indication of empty batteries
• Replace the battery or connect the mains adapter as
A
soon as blinks and Replace batteries is
scrolled.
Remove batteries if they are empty or if the unit will
not be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
1-4
POWER SUPPLY / BASIC FUNCTIONS
Mains adapter (supplied or optionally available)
Only use the AY 3170 mains adapter (4.5 V/300 mA
direct current, positive pole to the center pin). Any
other product may damage the set.
1 Make sure the local voltage corresponds to the
adapter´s voltage. If your mains adapter is equipped
with a voltage selector, set this selector to the local
mains voltage if necessary.
2 Connect the mains adapter to 4.5V DC on the set and to the wall outlet.
Note: Always disconnect the adapter if you are not using it.
Headphones (SBC HE205 or HL351)
• Connect the supplied headphones to LINE OUT/p.
Note: LINE OUT/p can also be used for
connecting this set to your HiFi system. Adjust the
volume and sound on both the CD player and your
HiFi system.
IMPORTANT!
• Hearing safety :
Do not play your headphones at a high volume. Hearing experts advise that
continuous use at high volume can permanently damage your hearing.
• Traffic safety :
Do not use headphones while driving a vehicle. It may create a hazard and it is
illegal in many countries. Even if your headphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high
that you cannot hear what is going on around you.
Playing a disc
With this set you can play
–all pre-recorded audio CDs
–all finalized audio CDRs and CDRWs
–MP3-CDs (CD-ROMs with MP3 files)
1 Push the ••••OPEN 2 slider to open the CD lid.
2 Insert a disc, printed side up, by pressing gently on the
disc´s centre so that it fits onto the hub. Close the lid
by pressing it down.
3 Press 2; to start playback.
. yEXpanium and Reading CD are displayed
briefly. Playback starts.The current track number and
the elapsed playing time are displayed. For a MP3
track, the album number is also displayed and the file-
name is scrolled once.
4 Press 9 to stop playback.
Replace bat
yThe total number of tracks the number of albums
on an MP3-CD and the total playing time (of an audio
disc only) are displayed.
5 To remove the disc, hold it by its edge and press
the hub gently while lifting the disc.
6 Press 9 again to switch off the player.
Notes:
- After pressing 2; it may take some time until the
first MP3 track is played.
- The display clears automatically after 20 seconds if
no controls are operated in the stop mode.
4 STOP 56
[MP3]