Page 2
Lithium Polymer batteries are volatile. Use provided Recon Scout robot Notice: and Recon Scout OCU chargers only. Failure to do so may cause fire which may result in personal injury and/or property damage. Changes or modifications not expressly approved by ReconRobotics could void the user’s warranty and could void the user's authority to operate the equipment .
C h a r g e r s Do not attempt to service the Recon Scout robot yourself. Refer all non- routine servicing to qualified service personnel. Repairs or modifications F i e l d M a i n t e n a n c e not conducted by authorized personnel may result in the voiding of warranty and/or Annual Maintenance Plans.
Please inspect the inventory in this package to ensure that all materials are present. This Recon Scout® XT and Rescue robots have enhanced water resistance capabilities, which means that it can be safely driven through puddles, used in heavy rain, or briefly If any of the materials are missing, please contact support@reconrobotics.com for...
Stabilizer First, give them a full charge. Make sure the Recon Scout robot and OCU are off (pin in the robot, switch off on the OCU). Charge them for a full six hours. If the lights on the OCU start flashing, there may be a problem with the charger or the battery.
OCU and robot must match for successful operation. To deploy multiple Recon Scout robot lands, let it sit still for a few seconds before driving. The Recon Scout robot Scout units within the same area of operation, different channels must be used.
How long will the Recon Scout robot run on a full charge? Setting up the OCU The actual lifetime of a Recon Scout robot will vary depending on the amount of driving and Rotate antennas to an upright position as shown.
Plug OCU charger unit electrical cord into charger transformer socket on the If you have a Recon Scout IR, XT or Rescue robot, you may also want to OCU charger. lightly dust off the IR Blister to ensure the light sensor stays clear.
Page 9
Telecommunications and Information Administration upon request of either agency. When multiple Recon Scout robots are available on separate frequencies, the agency deploying them must deploy a Channel C Recon Scout robot first, followed by a Channel A, followed by a Channel B.
Page 10
FCC Logbook The usage of the Recon Scout® robot and related equipment is subject to the The usage of the Recon Scout robot is subject to maintenance of a logbook. Please following conditions: use the following sheet to record the date of operation, the start and stop times, channel information, the location of usage, a brief reason for usage and a point of contact.
Need help?
Do you have a question about the XT and is the answer not in the manual?
Questions and answers