Step 1. Connect The Access Point - ViewSonic WAPBR-100 User Manual

Step 1. Connect the Access point.

1. Make sure you have all the setup information from your Internet Service
Provider (ISP).
2. Make sure that all network hardware is turned off, including the Router,
computer(s), and cable or DSL modem.
3. Connect a standard Ethernet network cable to the Access Point.
Connect the other end of the Ethernet cable to a Switch or Router. The
Access Point will then be connected to your 10/100 Network.
4. Connect the AC power adapter from the power jack on the back of the
Access Point to an AC wall outlet as shown or to a power strip with surge
protection. The power LED on the front of the AP turns blue when there
is power.
Power Jack
3-in-1 Access Point
ViewSonic
AC Power Adapter
Back of AP
AC Wall Outlet
10