2) Please ensure that the transmitter and receiver binding success, and the receiver has been set up in accordance with the failsafe. 3) Ensure both the throttle stick and the throttle trim of your F6TB stay at the lowest positions before operation.
4) Antenna is stretchable, easy to carry and convenient to packing 5) Clear and legibility of the code screen, easy and convenient to debug 6) The system adopts 2.4G FHSS, compatible with FLY-DREAM V3 system. 7) High frequency output power can be adjusted, more humanized and more environmental protection 8) Save eight of fixed wing plane.
Press “ENTER” and gets into “channel reverse setting” interface, screen display as : Press “DOWN” Press “UP” Change channel by press “DOWN”, press “UP” change channel reverse setting.Please save the setting after confirm, and gets into “Dual rate setting”. Press “EXIT” to exit the setting. FLY-DREAM WWW.FD-RC.COM...
”ENTER” button save setting, and enter ”D/R setting”interface. F6TB transmitter can adjust three channels of small rudder proportion (CH1,CH2...CH20) . During use, you can through the “D/R” switch on the left of transmitter to realize the small and big rudder change.
Press “UP” or “DOWN” Press “UP” or “DOWN” key to change low power supply scheme, F6TB can choose 1 s lithium battery (1 c. LP), 2 s lithium batteries (2 c. LP) or 4 cell dry battery, nickel metal hydride, nickel cadmium battery (4 c.
Put up the throttle stick, at the beginning of timer; Throttle stick in idle, pause timer; Timing to the set value, the remote control buzzer will slow ring alarm; switch up the timer, closed down the timer. 5.2 Transmit power setting After into senior menu, press “EXIT” into “Transmit power ” FLY-DREAM WWW.FD-RC.COM...
There are four kind of hand model for choosing(F6TB) Make the switch on the back of F6TB to MODE1 mode, press “UP” or “DOWM” can choose Mode1 or Mode3, Make the switch on the back of F6TB to MODE2 mode, press “UP” or “DOWN”...
4) Turn off the power to the receiver. Failsafe is now set. 8 Simulator mode Insert one side of simulator 3.5 audio nipple into F6TB “D.S.C” hole, the screen will display as: The RF function of F6TB is closed, the transmitter output PPM signal to simulator for computer simulation of flight.
Page 12
FCC WARNING Caution: Any changes or modi? c ations to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.