Related Manuals for Teasi NAV-BIKTS
Summary of Contents for Teasi NAV-BIKTS
- Page 1 User Manual Teasi SPC NAV-BIKTS Manufacturer:Shenzhen Meilan Technology Co.,Ltd Address:402 Yongkaili building, Xixiang road NO.: 7, Baoan, ShenZhen, China, 518102 Contact: Sheng Hou Tel: +86 0755 23159119 E-mail: housheng@meilankj.com...
- Page 2 I. Product Appearance and Button Name Teasi Core (BT name: Teasi Core) 1. USB charging interface/USB rubber stopper 2. Long press: power on/off; short press: backlight on/off; 3. Reset 4. Buzzer, Sound off in the menu only refers to steering notification tone and warning tone off, button tone cannot be set off;...
-
Page 3: Speed/Cadence Sensor
Short press: Exit search smartphone Short press: Start search sensors/search next sensor/exit Speed/Cadence sensor ( BT name:Teasi SPC) Wireless speed/cadence sensor Wheel magnet Pedals magnet II. Installation Installation of Teasi Core Fix Teasi Core on HR bracket as shown in the figure below... - Page 4 Installation of speed/cadence sensor A. Install pedals magnet (RPM) and wheel magnet (Speed) in corresponding positions as shown in the figure below: Tear the 3M adhesive on the back of pedals magnet off and stick pedals magnet inside the pedal connecting arm, and then tie up the 2 nylon straps to fix it, and cut unnecessary part down.
- Page 5 Fix Speed/cadence sensor on corresponding position of bike as shown in the figure, and then tighten it with 2 nylon straps. Then, fix it again with a rubber hand...
- Page 6 Ⅰ. There is a CR2032 button cell inside the product to provide power and its service life is 4 months in general. Teasi Core or Tuhuna will fail to detect sensors when sensor cell is dead or sensor is damaged.
-
Page 7: Teasi Core Has 2 Working Modes
Tuhuna or Teasi Core; 2. Teasi Core This product is provided with a built-in battery that can be charged with a charger above DC 5V, 500 mA or PC USB interface when the battery is too low to supply power to Teasi Core;... - Page 8 Bluetooth signal is lost in updating process, Teasi Core will return to its old version and will upda te again when it is connected to the APP next time.
- Page 9 Please note: You need to make sure that Teasi Core or sensors are not connected to other Bluetooth equipment and can be effectively connected to Tahuna; The status bar displayed after Teasi Core is successfully connected to Tahuna. Successful connection to Tahuna...
- Page 10 This product also has notification feature, for example, phone, email, over speed and water notifications which you can set on the APP. However, this feature can only be used when Teasi core is used together with APP. Examples are as below:...
- Page 11 Pairing method for sensors and Teasi Core Long press for 2 sec and then release it after hearing the buzzer sounds twice, then the Teasi Core will enter the mode to pair and connect with sensor; after the following interface is shown, short press to search sensor;...
- Page 12 In stopwatch working mode, some data may not be displayed, for example, data is displayed ——, the reason is that: 1. These data are all from APP, and APP is not connected when Teasi Core is working independently, so there is no data source;...
- Page 13 Start and stop of riding When Teasi Core is prepared for work, the prompt box as shown in the left figure will be displayed on the screen; when riding is suspended, the prompt box as shown in the right figure will be displayed on the screen;...
- Page 14 Bluetooth can bu used in Europe without restriction. CE Statement Hereby, Shenzhen Meilan Technology Co.,Ltd declares that this Teasi SPC ，NAV-BIKTS is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. Use the Teasi SPC in the environmen t with the temperature between -20℃ and 45℃.
-
Page 15: Fcc Statement
FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.