1. Manuals
  2. Brands
  3. Monde Synthesizer Manuals
  4. Controller
  5. Ribbonz
  6. User manual

Monde Synthesizer Ribbonz User Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

Thank you for purchasing the Monde Synthesizer Ribbonz controller. We hope Ribbonz provides you with many years of enjoyable operation.

Included are:

Ribbonz controller
12VAC power pack (custom version)
Two meter, nine-pin-bayonet interconnect cable (Standard version)
Eurorack breakout panel with 2 x 3M machine screws and ribbon cable to connect to the Eurorack backplane for power supply voltages (Standard version)

Precautions

Please follow these precautions:
Indoor use only - do not expose to moisture, do not expose to direct sunlight.
Clean with mild house-hold detergents only.
Do not expose the sensors to petroleum-distillate solvents.
Ribbonz Standard User Guide
www.mondesynthesizer.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ribbonz and is the answer not in the manual?

Questions and answers

Summary of Contents for Monde Synthesizer Ribbonz

  • Page 1 Ribbonz Standard User Guide www.mondesynthesizer.com Thank you for purchasing the Monde Synthesizer Ribbonz controller. We hope Ribbonz provides you with many years of enjoyable operation. Included are: Ribbonz controller 12VAC power pack (custom version) Two meter, nine-pin-bayonet interconnect cable (Standard version)
  • Page 2 Note: The Eurorack-format ribbon cable follows the usual red-stripe on bottom orientation. Observe the ribbon cable orientation at both ends. Failure to do so can damage the Ribbonz. Introduction The Monde Synthesizer Ribbonz Standard is a ribbon controller consisting of three parts: remote controller, interconnect cable, and Eurorack-format breakout panel. This instrument provides: Wide-range, tuneable and scalable frequency Control Voltage (CV) with selectable portamento destinations.
  • Page 3 Note: the LED pulses at the LFO frequency and blanks between triggering and expiration of the delay period. Outputs Figure 4 depicts the Ribbonz Standard Breakout Panel with 3.5mm jacks and nine-pin-bayonet socket. Figure 4 - Ribbonz Standard Breakout Panel Figure 5 depicts the Ribbonz Custom Rear Panel with 1/4" phono jacks and AC power input.
  • Page 4 Figure 5 - Ribbonz Custom Rear Panel Typical applications of these signals are: CV1 (PCV 1) controls Voltage Controlled Oscillator (VCO) frequency or Voltage Controlled Filter (VCF) cutoff frequency. CV2 (PCV 2) controls VCO frequency or VCF cutoff frequency. Gate controls Envelope Generator (EG) start and stop.

Table of Contents