How to Power On To turn on Invis push the button that is located on the right side of the LED (point 2). The strap, via LED, will start to show the starting procedure. After 5 sec. it will begin to work.
USB cable, or charging when moisture is present can cause fire, electric shock, injury, or damage to the Invis or other property. Be sure the Invis and the Invis charger are dry before charging. Make sure that the USB plug is fully inserted into the charger before you plug the adapter into a power outlet.
Connect with the Invis strap To check if the Invis is connected or to connect it with your phone, please select the Invis application. Go to “Edit profile” button which is located on the top, left of the screen. If you see the “Empty screen” please click “Search” and wait a moment. After a few seconds you should be able to see “Detected devices”...
Invis Communication The Invis was designed in a way as not to change your habits or the design of your watch. This is why the communication between you and the strap is based on the following actions: Through multicolor LED Invis provides you an information about notifications, alarms, phone calls, messages and many more.
≥ 90% energy of the maximum charge Starting procedure Every time after the Invis is turned on, a starting sequence is activated. It consists of the elements listed below. If the pattern on a device differs from mentioned below, go to troubleshooting section for more information.
Data are collected at all times when the Invis is turned on, and it synchronises the data automatically with your phone. It is really important to set your age, height, and weight. It allows the Invis to make more precise measurements of your activity. In the Settings section you can choose metrical as well as imperial units.
Loss Prevention When you walk away from your phone, the Invis will vibrate to let you know. With this function, the risk of leaving your phone or having it stolen decreases dramatically. The feature is based on Low Energy wireless protocol range. The vibration starts about 30 seconds after loose Low Energy wireless protocol connection.
Page 34
If you are not able to see the proper starting procedure a list of situation could happened. First, please make sure that the Invis is charged. To do so please put the strap on a charger for at least 15 minutes. Go to the Charging section to get information about proper charging.
Page 35
Invis visibility by phone. First, please check again if the application has recognized the Invis. To do this, go to “Edit Profile” and tap on the search button. Please repeat this for ~30 seconds. Sometimes, the mobile application needs more time to be able to detect the Invis.
Invis. You may be more likely to experience irritation from the Invis if you wear it too tightly. Remove the Invis periodically to allow your skin to breathe. Keeping Invis clean and dry will reduce the possibility of skin irritation. If you...
Drying In the situation the Invis will get wet, don’t try to make it dry in micro oven, over, dryer or similar products. Put it in a warm and dry place in room temperature.
In addition, the purchase of Invis Sp. z o. o. products may be considered as purchasing a license for Invis software and software supplied by other vendors that the device consist of.