How To Assemble And Operate The Vacuum; Variable Speed Control - Bank Vacuum MINT Owner's Manual

How to Assemble and Operate the Vacuum

How to Assemble and Operate the Vacuum
The vacuum, hose, wand and accessories are packed separately�
1� Push the hose cuff into the hose inlet on the top of the bag compartment
until it clicks into place (Fig� 1)�
2� Attach the electrical cord from the hose into the plug underneath the carry
handle (Fig� 2)�
How to Extend the Wand
Grasp the wand extension grip and pull up on the hose handle to extend the
wand to the desired length�
On/Off Switch
1� To turn on the vacuum, push the power pedal on the top of the vacuum�
2� To turn off the vacuum, push the pedal again�
3� To turn the power nozzle on, turn the vacuum on first, then push the
On/Off switch on the hose handle to the "On" position�
Full Bag Indicator
1� If the full bag indicator appears, change the vacuum bag�
2� If the full bag indicator appears, but the vacuum bag is not full, check the
hose for a clog�
NOTE: When cleaning with a tool (dusting brush, upholstery tool or crevice
tool), the full bag indicator may appear� In this case, continue
cleaning, as the indicator will likely go off once the tools are no
longer in use�

Variable Speed Control

To adjust the motor power, slide the variable speed control on the canister
body to the desired motor speed�
Suction Relief Valve
To adjust the suction level, slide the suction relief valve on the handle to
reach the desired level of suction�
5
Fig. 1
Fig. 2