John Lewis JLEBSWF01 User Manual page 15

Problem
The compressor operates continu-
ally.
The compressor does not start im-
mediately after pressing the Fast-
Freeze, or after changing the tem-
perature.
Water flows on the rear plate of
the wine cooler .
Temperature cannot be set.
appears on the display.
Door is misaligned or interferes
with ventilation grill.
The temperature in the wine cooler
compartment too low/too high.
Wine Cooler Freezer User Manual
Possible cause
Temperature is set incorrectly.
Many food products were put in
at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
The FastFreeze function is
switched on.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost melts on the rear
plate.
The FastFreeze or IntensiveCool-
ing function is switched on.
The appliance is in demonstration
mode.
The appliance is not levelled.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
Solution
Refer to "Operation" chapter.
Wait some hours and then check the
temperature again.
Refer to climate class chart on the rat-
ing plate.
Allow food products to cool to room
temperature before storing.
Refer to "Closing the door".
Refer to "FastFreeze function".
The compressor starts after a period
of time.
This is correct.
Switch off FastFreeze or Intensive-
Cooling manually, or wait until the
function resets automatically to set
the temperature. Refer to "FastFreeze
or IntensiveCooling function".
Keep the Functions button pressed
for approximately 10 seconds until a
long sound is heard and display shuts
off for a short time.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the same
time.
15