Page 1
INSTRUCTION MANUAL Twiins - Smart Series ® HANDSFREE 2.0 Phone, Music & Maps Components handsets LED indicator button USB charging cable USB charging port comfort pad spare mic band speaker velcro x2 units each foam x2 units...
Installation The Twiins® HANDSFREE 2.0 is very easy to install into a helmet. Remove the side padding from the inside of the helmet (if it can be removed) and place the handsets (2) and (3) at the height of your ears. The device is designed so that the main unit with the boom microphone is placed on the left side.
Page 3
HANDSFREE 2.0 To use the Twiins® HANDSFREE 2.0, it’s necessary to pair it to the Bluetooth® device you wish to connect it to (mobile phone, GPS navigator). While the device is switched off, hold the control button (1b) until the LED indicator (1a) begins flashing in Red and Blue. The mobile phone or GPS navigator will find the device under the name HANDSFREE 2.0.
Switching on/off 2“ Switching on: press and hold the button (1b) for a few seconds until the speakers provides an acoustic signal and the LED indicator (1a) begins to flash in Blue. 5“ Switching off: press and hold the control button (1b) for a few seconds until the speakers provides an acoustic signal and the LED indicator (1a) begins flashing in red before the device powers off.
Adjusting the volume The Twiins® HANDSFREE 2.0 device is pre-programmed with a volume level that allows for optimal listening at speeds of up to 80 km/h (50 mph). To adjust the volume, use the volume controls on the connected device.
• Do not paint or decorate the Twiins® HANDSFREE 2.0 as the casings may become damaged or impede correct operation. • Do not use chemical products, solvents or detergents to clean the Twiins® HANDSFREE 2.0 as these may damage the device.
You are responsible for the proper use of the Twiins® device, and for ensuring that it is compatible and does not violate traffic, safety or any other laws or provisions in your country or jurisdiction.