Advertisement
SYSTEM FUNCTIONALITY
fig. 1
fig. 2
MAXIMUM
HIGH
MEDIUM
LOW
8
IMPORTANT:
When you first get your
H1, charge it for six (6) hours.
POWER INSTRUCTIONS
To turn on:
1.
Place charged batteries into your H1's
zipped battery case as seen in figure 1.
2.
Hold the LED Thermadjust button for
five (5) seconds until it lights up.
To turn off:
1.
Hold the LED Thermadjust button
for five (5) seconds until the
glowing LED fades away.
TEMPERATURE SETTINGS
The H1 has four temperature settings:
1.
After turning your H1 on, press the
LED Thermadjust button until the light
changes color (figure 2). This will select
the next lowest level.
2.
When the LED indicator on the
Thermadjust button reaches blue,
pressing it again will revert it back to
red, the maximum heat setting.
BATTERY AND CONNECTION
CHARGING THE BATTERY PACK
1.
Disconnect the battery pack from
inside the zipped case.
2.
Remove the battery pack from your H1.
3.
Plug the charger into a wall outlet.
4.
Connect the battery pack to the charger
adapter as shown in figure 3.
5.
Disconnect the battery from the
charger when the charger's indicator
light changes from red to green.
•
If the charger indicator light is red,
the battery is charging. A full charge
typically takes under five (5) hours.
•
If the charger indicator light is green,
the battery has fully charged.
•
Do not leave the battery charging for
more than six (6) hours.
•
Disconnect from the wall outlet if either
the charger or the battery overheats.
•
Do not expose the charger to humidity
or moisture.
•
Universal Power Input: 100-240VAC /
47-63Hz
•
Maximum Charging Voltage: 12.6V
•
Maximum Charging Current: 1A
•
The batteries are Lithium Polymer.
Follow your local guidelines regarding
proper handling and disposal of
unwanted batteries. When in doubt,
use a battery-recycling program.
fig. 3
9
Advertisement
