Table of Contents
Advertisement
All the connected Mesh nodes will be displayed in this page.
Node: It shows the device name and MAC address.
Type: There are two types of the node. The Root node uplink to the gateway by wire, and connect with other mesh node by wireless
simultaneously.
Hops Count: The hops count refers to the number of intermediate devices through which data must pass between the Mesh node itself
and Root node. If the Hops Count number is more than 3, we recommend that you have to optimize your deployment of the device
location. System shows "—" when the node is Root or alone node
Neighbor Nodes: Display all the neighbor nodes which discovered by individually mesh node, no matter with its signal strength allowed
to link or not.
RSSI: The current signal strength of the node.
Signal Strength: There are four levels signal bar to display the RSSI, if the RSSI is below -76db, then it will display a red bar.
76
Advertisement
Table of Contents
