Spectrum iX12 Quick Start Manual

en
noTice
All instructions, warranties and other collateral • A lways ensure all batteries have been properly charged
documents are subject to change at the sole discretion prior to using the model.
of Horizon Hobby, LLC. For up-to-date product literature, • A lways check all servos and their connections prior to
visit horizonhobby.com and click on the support tab for each run.
this product. • N ever operate your model near spectators, parking
areas or any other area that could result in injury to
meaning of special Language
people or damage of property.
• N ever operate your model during adverse weather
The following terms are used throughout the product
conditions. Poor visibility can cause disorientation and
literature to indicate various levels of potential harm when
loss of control of your model.
operating this product:
• N ever point the transmitter antenna directly toward the
warning: Procedures, which if not properly followed,
model. The radiation pattern from the tip of the antenna
create the probability of property damage, collateral
is inherently low.
damage, and serious injury OR create a high probability of
• I f at any time during the operation of your model you
superficial injury
observe any erratic or abnormal operation, immediately
cauTion: Procedures, which if not properly followed, create
stop operation of your model until the cause of the
the probability of physical property damage AND a possibility
problem has been ascertained and corrected.
of serious injury.
noTice: Procedures, which if not properly followed, create
a possibility of physical property damage AND a little or no
possibility of injury. • F ailure to exercise caution while using this product
and comply with the following warnings could result in
product malfunction, electrical issues, excessive heat,
warning: Read the ENTIRE instruction manual
FIRE, and ultimately injury and property damage.
to become familiar with the features of the product
• R ead all safety precautions and literature prior to use
before operating. Failure to operate the product correctly
of this product
can result in damage to the product, personal property and
• N ever allow minors to charge battery packs
cause serious injury.
• N ever drop charger or batteries
This is a sophisticated hobby product. It must be operated
• N ever attempt to charge damaged batteries
with caution and common sense and requires some basic
• N ever attempt to charge a battery pack containing
mechanical ability. Failure to operate this Product in a safe
different types of batteries
and responsible manner could result in injury or damage to
• N ever charge a battery if the cable has been pinched
the product or other property. This product is not intended
or shorted
for use by children without direct adult supervision. Do not
• N ever allow batteries or battery packs to come into
attempt disassembly, use with incompatible components
contact with moisture at any time
or alter product in any way without the approval of Horizon
• N ever charge batteries in extremely hot or cold places
Hobby, LLC. This manual contains instructions for safety,
(recommended between 50–80˚ F or 10–27˚ C) or
operation and maintenance. It is essential to read and
place in direct sunlight
follow all the instructions and warnings in the manual, prior
• A lways disconnect the transmitter after charging, and
to assembly, setup or use, in order to operate correctly and
let the charger cool between charges
avoid damage or serious injury.
• A lways inspect a new battery before charging
• A lways terminate all processes and contact Horizon
age recommendation: not for children under 14.
Hobby if the product malfunctions
This is not a toy.
• A lways keep batteries and charger away from any
material that could be affected by heat (such as
noTice: This product is only intended for use with
ceramic and tile), as they can get hot
unmanned, hobby-grade, remote-controlled vehicles and
• A lways end the charging process if the charger or
aircraft. Horizon Hobby disclaims all liability outside of the
battery becomes hot to the touch or starts to change
intended purpose and will not provide warranty service
form (swell) during the charge process
related thereto.
warranTY regisTraTion
Visit www.spektrumrc.com/registration today to register your
support Videos:
product.
For helpful videos on programing the Spektrum™ iX12
transmitter and other Spektrum Transmitters go to
https://www.spektrumrc.com/

TransmiTTer FuncTions

safety precautions
Function
1 LED
2 Right Trim
3 Right Knob
4 Switch E
5 Switch G
6 Switch F
Throttle Adjustment (Mode 1,3)
7
Throttle Adjustment (Mode 1,3)
Mode Change, Gimbal
8
Centering Screw
Throttle/Aileron (Mode 1)
Elevator/Aileron (Mode 2)
9
Throttle/Rudder (Mode 3)
Elevator/Rudder (Mode 4)
10 Left/Right Gimbal Stick

charging warnings

Tension Adjustment
11 Up/Down Gimbal Stick
Tension Adjustment
Elevator Trim (Mode 2, 4)
12
Throttle Trim (Mode 1, 3)
27
26
25
24
23
22
21
28
20
19
18
17
16
54003
© 2017 Horizon Hobby, LLC.
DSMX, the DSMX logo, Spektrum AirWare and the Horizon Hobby logo are trademarks
or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with
permission of Bachmann Industries, Inc.
Android is a trademark of Google Inc. The Bluetooth
trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Horizon Hobby is
under license. The WiFi logo is a registered trademark of WiFi Alliance.
All other trademarks, service marks and logos are property of their respective owners.
EU patent 6007706. Other patents pending.
Function Function
Aileron Trim (Mode 1,2) 24 Switch C
13
Rudder Trim (Mode 3,4)
25 Switch B
14 Neck Strap Mount
26 Switch D
15 Speaker Grill
27 Switch I
16 Touchscreen LCD
28 Gimbal travel limiter covers
Rudder Trim (Mode 1,2)
17
29 Left Trim
Aileron Trim (Mode 3,4)
30 Power Button
Throttle Adjustment (Mode 2,4)
18
Throttle Adjustment (Mode 2,4) 31 Antenna 1
32 Switch A
Elevator Trim (Mode 1,3)
19
Throttle Trim (Mode 2,4) 33 Left Lever
20 Mode Change Gimbal 34 Serial Interface Port
Centering Screw
35 Audio Jack
Elevator/Rudder (Mode 1)
36 Battery Cover
Throttle/Rudder (Mode 2)
37 Right Lever
21
Elevator/Aileron (Mode 3)
38 Switch H
Throttle/Aileron (Mode 4)
39 Handle/Antenna 2
22 Left/Right Gimbal Stick
40 Memory card port
Tension Adjustment
41 USB/Charging port
Up/down Gimbal Stick
23
Tension Adjustment
3
30 1
39 31
4
29 2
38
5
6
7
8
37
9
10
11
12
13
14
36
15
34
® word mark and logos are registered
Created 11/17
iX12 iX12
12- Cha n nel 2.4GHz DS MX 12- Cha nn el 2. 4G Hz D S M X

charging

The first time you charge the transmitter, the charge time may be 15-20
hours. Always charge the transmitter on a heat-resistant surface.
charging:
1.
Connect the power supply to a power outlet using the appropriate adapter
and the Micro USB cable to the charge port on the transmitter as shown.
2.
A Blue LED will flash while charging. Also a fast press of the power switch
will bring the Charge Battery icon to the color touch screen display.
3.
When the system is powered ON, charging is complete when the blue
flashing LED stops. Disconnect the USB cable once charging is complete
and disconnect the power supply from the power outlet.
cauTion: Never leave a charging battery unattended.
cauTion: Never change the low voltage limit for Li-Ion batteries
below 3.3V. Doing so could over-discharge the battery and damage
both battery and transmitter.
cauTion: Never charge the battery outside of the transmitter due
32
to the battery monitoring system not recognizing the
charge of the battery when it is not charged inside the
transmitter. This can cause the system to give false low battery warnings.
33

Powering uP/down The iX12 TransmiTTer

The iX12 features a push button ON/OFF switch.
1.
To power on the transmitter, push and hold the Power button for several seconds until
the LCD screen displays the start up screen. Similar to other smart devices, startup takes
~1 minute at which time the Spektrum Airware™ app launches automatically and takes
approximately 1 1/2 minutes to fully launch.
35
2.
To power down the transmitter, push and hold the Power button for several seconds until
the Power Off / Reboot prompt shows on the screen. Press Power Off to shutdown.
Tip
Pressing the Power button once will put the display to sleep but the radio will continue to transmit normally. Press the
power button again to wake up the screen.
40 Double pressing the Power button will open a window allowing you to select RF On/Off, LCD On/Off, or press and hold
to put both RF and LCD into sleep mode.
41
It is recommended you use the sleep mode rather than turning the system Off on flying days.
A i rc ra ft S y st em A i rc ra ft S y st em
® ®