Page 1
Model #050013 Component #692543 ELECTRONIC WALL SENSOR INSTRUCTION MANUAL THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USE, READ CAREFULLY AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY AND/OR PROPERTY DAMAGE.
IMPORTANT SAFEGUARDS WARNING: This product can expose you to chemicals known by the State of California to cause cancer and birth defects or other reproductive harm . Wash hands after handling. SAFETY WARNINGS FOR WALL SENSORS READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury .
OPERATING INSTRUCTIONS READ “SAFETY WARNINGS FOR WALL SENSORS” BEFORE USE. Live wires may not be detected if wires are shielded or in conduits or behind thick walls or are more than 2 in . (51 mm) away from the scanned surface, or in concrete, behind a plywood shear wall or metallic wall covering, or if moisture is present in the environment or on scanned surface or on the sensor .
DETECTING METALS & CALIBRATION NOTE: The default detection mode of the sensor at the startup is “Metal” indicated by I beam icon ( ) on LCD display . Calibrate the sensor before use . 1 . Press the On/Off (red) button to turn on the sensor . The green LED indicator turns on and followed by a short beeping sound from the internal buzzer .
DETECTING WOOD & CALIBRATION NOTE: The default detection mode of the sensor at startup is “Metal” indicated by I beam icon ( ) on LCD display . Calibrate the sensor before use . 1 . Press the On/Off (red) button to turn on the sensor . The green LED indicator turns on and followed by a short beeping sound from the internal buzzer .
6 . Place the sensor onto the surface to be scanned and move the sensor side to side . As the sensor approaches/ Live Wire moves away from the live wire under the surface, the signal detection strength bar and % value indicators on Surface LCD display increase/decrease .
MAINTENANCE & CLEANING Clean the housing using only a soft cloth or cotton swab with water or medical alcohol . Do not use cleaning agents or solvents . Do not let any liquid enter the housing area . Allow the tool to fully dry before use . Avoid storing the sensor in extreme temperature conditions .
1-YEAR LIMITED WARRANTY Express and Exclusive Limited Warranty to Original Retail Buyer Every ALLTRADE product is inspected before leaving the factory . This product is warranted to be free of defects in ® material and workmanship for a period of one year from the date of original purchase . If a defect appears within one year after the date of purchase, the purchaser may return the item, together with a purchase receipt or other appropri- ate proof of purchase to the place of purchase .