Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for OZ Trempoline Rectangular In-Ground Trampoline
-
Page 2: Table Of Contents
Safety Tips Welcome At Oz Trampolines, we are passionate about your family’s safety when using our Thank you for purchasing with Oz Trampolines. We have designed our trampolines trampolines and accessories. We have put together a list of safety tips and advice to be safe and ensure that the parts last many years in the harsh Australian climate. -
Page 3: Trampoline Parts
Trampoline Parts - 14ft x 10ft Trampoline Parts - 11ft x 8ft Plug End Socket End Corner Section - Right Corner Section - Left Middle Section - Long Side Corner Section Corner Section Corner Section Corner Section Plug - Socket Plug - Socket Plug - Plug Plug - Plug... -
Page 4: Digging The Hole
Digging the Hole Digging the Hole Installation Time Step 1 This will vary depending on trampoline size, equipment used and soil conditions. The Oz Trampolines To begin, mark out your required hole. It’s best to mark out a rectangle around 10cm wider than the measurements In-ground Trampolines have been designed to minimise the need to excavate too much soil. -
Page 5: Frame Assembly
Building the Trampoline & Retaining Wall Frame Assembly - 11ft x 8ft Installation Time You will need two people to assemble the trampoline and wall. The time needed is about half an hr. Frame Layout - 11ft (3.35m) x 8ft (2.45m) You will need: •... -
Page 6: Mat Assembly
Mat Assembly Fitting the Retaining Wall It is now time to fit the retaining wall to the frame. There are eight Wall Panels with four of them having hole cut-outs only in the corners (these are for the straight sides). Four panels have cut-outs in the corners and four cut-outs in the middle of the wall panel (these are for the corners). -
Page 7: Safety Pads Assembly
Safety Pads Assembly Enclosure Parts Installation Time You should allow approximately 20 minutes for this stage. Enclosure Poles Sleeved Netting Step 1 with Foam Inserts Quantity (Full Enclosure): 8 Quantity (Half Enclosure): 4 Quantity: 1 Lay the Safety Pads on top of the trampoline, aligning the pad section joins with the joins in the frame. - Page 8 Full Enclosure Assembly Half Enclosure Assembly Step 1 Step 1 Take the Enclosure Net complete with foam inserts and lay flat on the trampoline mat with the zip entrance facing Take the Enclosure Net complete with foam inserts and lay flat on the trampoline mat. towards you.
- Page 9 • Free Delivery Australia Wide* • Round, Oval and Inground Trampolines • Easy Returns* • Long Warranties • Largest Range of Parts in Oz • High Quality - Built to Last • Easy Claim Warranty Service • Friendly Advice 7 Days a Week •...
Need help?
Do you have a question about the Rectangular In-Ground Trampoline and is the answer not in the manual?
Questions and answers