Page 2
2. Remove the plastic cable clamp from the bottom center of the paddle. 3. Solder the shield on the cable from the MFJ-422B-X to the solder lug located between the rear rubber foot and the cable clamp on the bottom...
Page 3
4. Solder the red wire in the cable from the MFJ-422B-X to the solder lug on the dot post of the paddle and the white wire to the solder lug on the dash post. 5. If battery operation is desired, install a 9V transistor battery in the battery snap in the MFJ-422B-X and slip the battery into the battery holder.
Need help?
Do you have a question about the MFJ-422B and is the answer not in the manual?
Questions and answers