Table of Contents
Advertisement
Quick Links
Reset
LED
Operating method:
Turn On : Press 【PAIRING】till the LED flash, the n release.
Pairing : Press 【PAIRING】till red/green blinking light, then release. Meanwhile, switch your
Bluetooth Headset into pairing mode.
Two devices should connect themselves and green LED flashing shows connected.
LED
RED/GREEN BLINKING
GREEN FLASH
RED FLASH
RED LIGHT ON
User's Guide
(Bluetooth Phone Adaptor)
Charger Jack
MODE
PAIRING
NORMAL
LOW-BATTERY
RE-CHARGING
Ear Phone Jack
REMARKS
GREEN INDICATES
BATTERY FULL.
Pairing
1
Advertisement
Table of Contents
Summary of Contents for J-3 International Holding Co. BT002001
- Page 1 User’s Guide (Bluetooth Phone Adaptor) Charger Jack Ear Phone Jack Reset Pairing Operating method: Turn On : Press 【PAIRING】till the LED flash, the n release. Pairing : Press 【PAIRING】till red/green blinking light, then release. Meanwhile, switch your Bluetooth headset into pairing mode. Two devices should connect themselves and green LED flashing shows connected.
-
Page 2: Transferring Calls
Bluetooth Headset Volume Adjust Charging Status LED Function key Status Operation: ◎Turning on the headset Switch on the headset by pressing “Function key” max. 3 seconds and a beep tone with LED flashing indicates the headset is on. ◎Putting HS in Pairing Mode “Function key”... - Page 3 ◎Disconnecting calls While a call is in session on the headset, press the “Function key” to disconnect the call. After the call is disconnected, the green LED will flash normally. ◎Putting HS in Standby Mode The headset can be put into Standby Mode in different ways: Turning on the headset but not going into Pairing Mode After successfully pairing the headset Disconnecting from a call...
-
Page 4: Battery Information
J-3 International Holding Co.,LTD Electronic Division FCC Safety Statements The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. - Page 5 J-3 International Holding Co.,LTD Electronic Division conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the BT002001 and is the answer not in the manual?
Questions and answers