Wire And Braided Rope Installation; Two Speed Motor Case Drain Plumbing - BRADEN PD12C Series Installation Maintenance And Service Manual

WIRE AND BRAIDED
ROPE INSTALLATION
ANCHORING WIRE ROPE
Take the free end of the wire rope and insert it
through the small opening of the anchor pocket.
Loop the wire rope and push the free end about _ of
the way back through the pocket. Install the wedge,
then pull the slack out of the wire rope. The wedge
will slip into the pocket and secure the wire rope into
the drum. The anchor is designed to accommodate
several different sizes of wire rope. You may anchor
7/16 and 1/2 in. (11 & 13 mm) wire rope by inserting
the wedge, large end first. Anchor 9/16 and 5/8 in.
(14 & 16 mm) wire rope by inserting the wedge, small
end first.
ANCHORING BRAIDED ROPE
A special wedge is used to anchor 1 and 1 1/8 in. (25
& 28 m) braided rope. The installation procedure is
the same as for anchoring wire rope.
Correct Installation
Figure 7
Incorrect Installation
Wedge not
fully seated
Figure 9
TWO SPEED MOTOR
CASE DRAIN PLUMBING
Winches built prior to 1991 with two speed motor,
Part No. 26182, have the motor case drain
connected to the drain port of the brake valve. This
may result in accelerated motor shaft wear and
leakage. The following modification should be made
to the motor hydraulic piping to prevent this type of
seal damage.
1. Remove the motor case drain hose from the
brake valve drain port and install plug, Item
1, into the valve port. Remove the hose from
the case drain port elbow, Item 4.
2. Install a new case drain hose, Item 2, onto
the motor case drain elbow, Item 4.
3. Install the tee adapter, Item 3, into the two-
speed motor shift valve drain port (identified
by long end cap).
4. Install the new motor case drain hose, Item
2, onto the tee adapter.
– 8 –
Drive from
this side
Wedge and wire
rope fully seated
in pocket
Figure 8
Wedge pulled
too far through
anchor pocket
Figure 10