NavWorx ADS600-B Installation And User Manual page 31

2010-04-20
Command Option
ENABLE CSID
DISABLE CSID
ENABLE PALT
DISABLE PALT
SET CALLSIGN <8 character callsign>
CAT <NOTYPE | LIGHT | SMALL | LARGE |
SET
VERYLARGE | HEAVY | MANEUVERABLE |
ROTORCRAFT | GLIDER |LIGHTERTHANAIR |
PARACHUTIST | ULTRALIGHT | UAV |
SPACEVEHICLE | EMERGENCY | SERVICE |
POINTOBSTACLE |CLUSTEROBSTACLE |
LINEOBSTACLE>
SET GPSANT <left|right> <x.y>
SET GPSANT nose <x.y>
SET GS <knots>
SET ICAO <hexadecimal>
SET LENGTH <x.y>
SET WIDTH <x.y>
Command Option
SET EMERGENCY <NONE | GENERAL | MEDICAL |
MINFUEL | NOCOMM | HIJACK | ACFTDOWN>
SET FLIGHTID O:<octal-number>
IDENT
ENABLE SAA
DISABLE SAA
Command Option
RESET
ENABLE SIM
DISABLE SIM
SET LOADER
Copyright 2009-2010 NavWorx ®
TRANSMITTER Commands
Description
Enable call sign identification flag logic.
Disable call sign identification flag logic.
Enable pressure altitude input.
Disable pressure altitude input.
Assign aircraft call-sign. The call-sign may not exceed 8 characters.
Must be Alpha-Numeric characters only. No other characters
allowed.
Assign aircraft category.
Set GPS antenna lateral axis [left or right of centerline] position in
meters.
Set GPS antenna longitudinal axis [from nose] position in meters.
Assign speed in knots which determines when aircraft is airborne.
Assign the aircraft's ICAO address in a hexadecimal format.
http://www.smalluas.com/download/ICAO_Annex_10_Volume_III.p
df
Set length of aircraft in meters.
Set width of aircraft in meters.
TRANSMITTER (Pilot Input) Commands
Description
Set emergency code.
Set flight ID as an octal 4 to 6 digit number.
SET FLIGHTID O:1200
Start IDENT. Mode status message is transmitted for 20 +/- 4
seconds.
Enable transmission of the temporary self-assigned address. The
self-assigned address will be transmitted instead of the ICAO
address.
Disable transmission of the temporary self-assigned address. The
ICAO address will be transmitted instead of the self-assigned
address.
UTILITY Commands
Description
Reset unit.
Enable simulation mode.
Disable simulation mode.
Used for updating unit software.
Page 31 of 46
P/N: 240-0008-00-02
All rights reserved. Printed in the U.S.A.
E.g.