(CIN # will be located on the CE Plate on your Sport Boat) Congratulations! You are now the proud owner of an Inflatable Sport Boat. Inflatable Sport Boats are manufactured to provide a premium inflatable boat with the highest quality material, hand crafted design, durability, and performance to last.
Operation and Safety Information WA R N I N G BEWARE OF OFFSHORE WINDS AND CURRENTS! It is the responsibility of the boat's operator to know all laws applicable to boats and to comply with those laws when equipping and operating the boat. Rules and regulations may vary depending on the following conditions: the location of the boat's operation and the requirements of local authorities;...
IMPORTANT!! PLEASE READ THIS INSTRUCTION MANUAL THOROUGHLY BEFORE ASSEMBLING OR USING PRODUCT. FAILURE TO ABIDE BY INSTRUCTIONS AND WARNINGS CAN CAUSE A MISUSE OF THE PRODUCT AND POTENTIAL INJURY HAZARD WATERSPORTS INDUSTRY ASSOCIATION RESPONSIBILITY CODE Be aware that there are risks in boating and Watersports that good judgment and personal awareness can help reduce.
• Always check the weather before operation. DO NOT use boat during winds or offshore currents. Product Details Inflatable Sport Boats offer a multitude of different sizes and types of inflatable dinghy boats. Please make sure to identify which Sport Boats model you have before reading these instructions.
Packing List Assembly and Disassembly Inflatable Sport Boats are manufactured to make it easy for consumers to set up and take down quick and easy. Make sure your product box came with everything listed below. ATTENTION! Never use a compressed air source, such as an air compressor.
Page 7
Video tutorial for assembly and disassembly available on our website and YouTube. https://inflatablesportboats.com/informational-videos/...
Step by step Disassembly and Storage 1. Follow step #1 in assembly. 2. Wipe down product completely before deflating. It is easier to clean while inflated. IMPORTANT: storing a wet product can cause mildew, mold, and can damage the product. 3.
Inflation Inflation takes approximately 8-12 minutes to completely fill the boat. Each size boat has a “Maximum PSI” clearly stated on the CE plate mounted on the boat. Never exceeded the maximum PSI.. To Inflate: 1. Use the foot pump provided in the product box. You can not over inflate the product by using the foot pump.
Operating Information CAPTAIN’S READ! It is the responsibility of the captain/driver of the boat to know all the laws applicable to boats and to follow those laws when operating the watercraft. The captain of the boat is fully responsible for all passengers and making sure the passengers have read and understood all rules and warnings that apply while occupying the watercraft.
Page 11
Warning! Do not over power and exceed the maximum weight of the motor! Operating Outboard Motor Overpowering can result in severe handling and/or stability problems with serious consequences. Use a safety lanyard. 1. Regular checks should be made on motor attachment screws. Loose screws Towing your Sport Boat will cause erratic boat operation and possibly the loss of your outboard The inflatable should only be towed using the D-rings near the bow on each side of...
1. The repair of a small leak or puncture less than ½ inch can be done with a round patch, 3 inches diameter, and minimum. 2. Cut the round patch. Use the patches enclosed with your Inflatable Sport Boats. 3. Place the patch over the area to be repaired, outline with a pen.
In the event of alterations; modifications made to the boat which have not been approved by the manufacturer, Inflatable Sport Boats, and which affect the “basic safety requirements,” this declaration no longer applies to that boat and is therefore null and void.
Page 14
Inflatable Sport Boats be determined to have been defective in material or workmanship. The decision to replace or compensate for a particular Boat or part shall be at the election of Inflatable Sport Boats. Inflatable Sport Boats may require such Boat or part to be returned to an authorized dealer or other specific location for examination.
Page 15
Manufacturer’s Certificate of Origin You will need the Manufacturer's Certificate of Origin to title and register your vessel. Please fill out with boat data provided in owner’s manual and on CE plate. The H.I.N and C.I.N are the same thing and begin with AST;...
Page 16
On Point Products 2105 Pasqual Dr., Roseville, CA 95661 www.inflatablesportboats.com | (530) 268-4757...