Table of Contents
Advertisement
Getting Started
To use the Trigno Personal Monitor, it must be first connected to a
PC with EMGworks in order to create a data collection protocol, and
load it onboard. Data can then be collected on the Personal Monitor
which communicates with up to 16 wireless sensors (and the optional
GPS module). The device can store up to 14 hours of recorded data
from all 16 sensors. Once the data collection session is completed,
the device is again connected to a PC running EMGworks in order to
download the collected data.
Figure 13: Using the Trigno Personal Monitor requires three
basic steps: 1) setup the desired data acquisition protocols in
EMGworks and download them onto the TPM; 2) Collect data on
the TPM using the protocols; 3) Transfer the collected data from
the TPM to EMGworks for analysis.
Loading Protocols on the Personal Monitor
To use the TPM as a mobile subject monitoring device, a protocol
for data collection must first be created on a PC and loaded on the
device.
Power on the TPM and connect it to a PC using the supplied USB
cable. After device drivers are installed, the following dialog will ap-
pear:
19
Setup
1
Protocol
Trigno
Collect
2
Data
Personal Monitor User's Guide
TM
Analyze
3
Data
Advertisement
Table of Contents
