Assembly - Poulan Pro XT195H42LT Operator's Manual

Poulan lawn tractor operator's manual
Hide thumbs Also See for XT195H42LT:
Table of Contents

Advertisement

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 1/2" wrench
Utility knife
(2) 3/4" wrench
Tire pres sure gauge
Pliers
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM
CAR TON
UNPACK CARTON
Remove all accessible loose parts and parts cartons
from carton.
Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
Slide extension shaft onto lower steering shaft.
Place tabs of steering boot over tab slots in dash and
push down to secure.
INSTALL STEERING WHEEL
Position front wheels of the tractor so they are pointing
straight forward.
Remove steering wheel adapter from steering wheel
and slide adapter onto steer ing shaft ex ten sion.
Position steering wheel so cross bars are hor i zon tal
(left to right) and slide inside boot and onto adapt er.
Assemble large flat washer, lock washer, bolt and
tighten se cure ly.
Snap steering wheel insert into center of steer ing
wheel.
Remove protective materials from trac tor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLL OFF SKID.

ASSEMBLY

STEERING
BOOT
EXTENSION SHAFT
CHECK BATTERY (See Fig. 2)
Lift seat pan to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE section of this
manual for charging instructions).
B
ATTERY BOX
DOOR
T
6
INSERT
BOLT
LOCK
WASHER
LARGE
FLAT WASHER
TABS
LOWER
STEERING
SHAFT
Fig. 1
S
EAT PAN
ERMINAL
02021
Fig. 2
STEERING
WHEEL
ADAPTER
TAB
SLOTS
03132
L
ABEL
T
ERMINAL

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents