Related Manuals for Classic Tech Development HP1291
Summary of Contents for Classic Tech Development HP1291
- Page 1 HP1290 (HP1291 + HP1292S) Cordless Stereo 900Mhz Headphone System User's Manual (draft)
- Page 2 INTRODUCTION This 900Mhz compact stereo headphone takes advantage of the very latest advances in wireless transmission technology and unique SRS surround effect so that you can listen to music or the sound from your TV set both in the house and outdoors.
- Page 3 INSTALLATION TRANSMITTER Connect the mains adapter provided to an electrical outlet. Connect the mains adapter cable to the DC IN input connector located on the transmitter rear panel. A cable is provided from the transmitter rear panel that can be connected to the audio outputs (Left and Right) present on a TV set, Hi-Fi system, VCR or radio-cassette player, or to a headphones/earphones output using the connector supplied.
- Page 4 Press “SRS” button to activate Surround Effect for unique audio enjoyment. , SRS and symbol are trademarks of SRS Labs, Inc. NOTE: You should then be able to move around freely from one room to another without any interference. If interference does occur (interruptions in the signal), press the "Auto Scan"...
- Page 5 WARNING: Never attempt to recharge conventional dry cells. Never use another type of battery or non-rechargeable batteries to replace the rechargeable (LR03/AAA) batteries supplied. When the headphones are not in use, move the switch to the OFF position to avoid damaging the batteries. The batteries must always be fully charged before use.
- Page 6 REPLACING BATTERIES Rechargeable batteries have a long service life. If it is however necessary to replace them, proceed as described below: Carefully remove the cloth padding around the left and right headphones. Install the new batteries in their housings as illustrated. Check for correct +/- polarity.
- Page 7 TECHNICAL SPECIFICATIONS Transmission mode : UHF stereo Carrier frequency : 900Mhz Operating voltage : Transmitter – 12.5 V 150 mA Receiver – 2.4 V (two rechargeable batteries, LR03/AAA size) Frequency response : 30 Hz – 11 KHz Distortion : 1% Signal-to-noise ratio : 55 dB Channel separation...
- Page 8 TROUBLESHOOTING NO SOUND Ensure that the mains adapter is pushed fully into the power outlet and that its cable is properly connected to the DC IN 12V connector on the transmitter. Ensure that the headphones On/Off switch is switched to the On. The headphones battery charge level may be too low.
Need help?
Do you have a question about the HP1291 and is the answer not in the manual?
Questions and answers