Subscribe to Our Youtube Channel
Related Manuals for Bogen TMC-4
Summary of Contents for Bogen TMC-4
- Page 1 TELEMEDIA CONTROLLER Model TMC-4 Installation and Operation Instructions TELEMEDIA CONTROLLER MODEL TMC-4 STATIONS IN USE PROGRAM WINDW LEARN ERROR POWER RELEASE # MANUAL/PROGRAM...
-
Page 2: Installation
MODEL TMC-4 Infrared transmitter to device under control. TAM-B PHONE SYSTEM EXT VOX ENABLE PAGING OUTPUT N.O. CONTACT CLOSURE A +24/48 POWER SUPPLY -24/48 (TRUNK ACCESS ONLY) Figure 1B - Connection of TMC-4 to Telephone System using TAM-B (1 Station Shown) -
Page 3: Program Commands
Remote control units vary 1. Press and hold down the MANUAL/PROGRAM key ([#]) for widely in signal output - too close to the TMC-4 may over- at least 5 seconds. All STATIONS IN USE LEDs will begin flash- load the receiver, too far will not provide proper signal ing. -
Page 4: Manual Operation
Return to the ready mode by pressing [#] [#]. 3. To teach the TMC-4 a command, enter a command number Operation on the TMC-4 keypad ([0] [0] to [2] [9], see Table 1). At this point the LEARN LED will begin flashing. Manual Operation 4.Aim the remote control at the PROGRAM WINDOW. -
Page 5: Specifications
TAM-B, the user, or the TMC-4. STATION INPUTS terminal block EXTERNAL INPUTS terminal block 2. The TMC-4 waits for DTMF tones or a disconnect code. If INFRARED SIGNAL OUTPUTS RCA jack key pad numbers [0] through [9], [#] [0] through [#] [9], or [*]... - Page 6 Copyright 2002 Bogen Communications, Inc. Part No. 54-5929-02r1 Printed in U.S.A. 0802...
Need help?
Do you have a question about the TMC-4 and is the answer not in the manual?
Questions and answers