Advertisement
1. Click on button to open a lid of the
kettle, add water.
The water level must not exceed the
maximum mark, and should not be
below the minimum.
3. Press the power button, the button
will light, the water will begin to heat
up.
1. Make sure it is disconnected from a power supply and wait until it cools down before
cleaning the kettle.
2. To extend a service life of the kettle, it must be cleaned regularly from the sediment.
3. If water quality is poor, repeat an above procedure. In no case do not use an iron brush and
any abrasive chemicals to clean the kettle.
4. Do not immerse the kettle and its base in water. Keep the outside of the pot dry.
Using
2. Close a lid, put the kettle on a
base.
4. After boiling water, the heating
will stop.
Precautions:
Опустіть
1. Add a vinegar.
Pour 0.5 l of vinegar into the
kettle and leave for 1 hour.
3. Boil water.
Boil water in a kettle and then
pour it off. Repeatedly wash the
kettle 4-5 times.
Care and cleaning
2. Pour off a vinegar.
Pour the vinegar out of the kettle and remove
the sludge residues using a damp cloth.
4. Wipe dry the kettle.
Use a dry cloth to wipe the outside of the
kettle.
Keep the kettle in a dry, well-ventilated place,
protecting it from dust, moisture and insects.
Advertisement
