Refrigerator Model Thetford N175 Lcd; Operating Instructions; Smart Energy Selection (Ses) - elddis Aspire 215A 2011 Owner's Handbook Manual

HOW TO USE YOUR MOTORHOME'S
EQUIPMENT

REFRIGERATOR MODEL THETFORD N175 LCD

A = Main switch (on/off)
B = Mode selection switch
C = Cooling level selection switch

OPERATING INSTRUCTIONS

When the caravan is on tow, the refrigerator
should only be operated electrically, i.e. from the
12V battery in the towing vehicle and not by
means of the bottled gas.
The refrigerator can be run on 230V or LP gas
whilst stationary.
CAUTION: Only use one source of energy at a
time.
WARNING: The refrigerator should not be
operated on LP gas whilst being towed or
when on a petrol station forecourt.
Switching on the refrigerator
• Clean the inside of the refrigerator before
you switch it on.
• Let the refrigerator run for at least eight
hours before you place food in it for the first
time.

SMART ENERGY SELECTION (SES)

When you start up the refrigerator (equipped
with Smart Energy Selection (SES)) you should
usually select the AUTO mode. The SES system
will then automatically select the best of the
three available energy sources. The system will
apply the following priority:
- mains voltage (230V)
- direct current (12V)
- liquid gas
D = Function LED
E = LCD display
If an energy source becomes available that has a
higher priority than the source the refrigerator is
currently using (e.g. if your vehicle engine is
started), the system will stop using the current
energy source and switch to the energy source
with the higher priority.
If a fault occurs in one or more of the possible
energy sources, the system will not generate an
error message while an alternative energy source
is still available. The SES system switches over
automatically.
Note: If none of the energy sources are available,
the blue LED flashes every second and an error
code is shown in the display.
Automatic models additionally allow you to select
the desired energy source manually.
Important: The memory of the SES system
saves every change made to the setting.
Consequently, the SES system will start up on
each subsequent occasion in the last-selected
setting.
1. Open the valve of the gas bottle.
2. Open the taps of the gas supply.
3. Press main switch (A). The function LED will
turn blue and all symbols on the LCD display
will light up.
4. Use the mode selection switch to select the
"Auto" function or one of the power supplies
that you want. The LCD display will show the
option you have selected.
5. Set the desired refrigerating cooling level by
9-14