Advertisement
Quick Links
EN
TECHNICAL HANDBOOK
You have just acquired the new XCAP-500 vehicle jump starter, also known as the Kap'SAM®.
We recommend that you read this manual all the way through before using the device for the first time.
It contains the information that will enable you to master and use the device on a day-to-day
basis very quickly and efficiently. Thank you for confidence.
DO NOT THROW AWAY THIS DOCUMENT:
KEEP IT IN A SAFE PLACE! ENSURE THAT THIS
DOCUMENT IS READ BY THE END USER!
PRECAUTIONS FOR USE
This device is not designed to be used
by anyone (including children) whose
physical, sensory or mental capacity
is reduced, or inexperienced or unin-
formed persons unless they have had
the benefit of prior monitoring or ins-
truction in the use of the device from
a person responsible for their safety.
Take care to ensure that children never
play with the device.
WARNING: There is a risk of explo-
sion if a vehicle battery is replaced
by the wrong type of battery. Dispose
of spent batteries as specified in the
instructions.
WARNING: When using on a rechar-
geable battery, there is a risk of ex-
plosive gases being emitted from that
battery. No flames or sparks.
Kap'SAM®
VEHICLE JUMP STARTER
X C A P - 5 0 0
When using the Kap' S AM®, the vehicle
battery must be placed in a sufficiently
well-lit place. The device is for use only
with 12 volt rechargeable batteries.
The device must be used in a tempera-
ture range of -20°C to +40°C inclusive,
and at a humidity of less than 70%.
The device is intended for indoor use
or outdoor use out of the rain.
The device must be used upright with
the handle at the top, as shown in the
photo below.
The maximum operating time for the
Kap' S AM® is 30 seconds per cycle.
Do not open the device and do not
attempt to replace any parts, apart
from the fuse (see the procedure
for Replacing the fuse).
7 6-
Advertisement
Summary of Contents for SAM Outillage Kap’SAM XCAP-500
- Page 1 TECHNICAL HANDBOOK Kap’SAM® VEHICLE JUMP STARTER X C A P - 5 0 0 You have just acquired the new XCAP-500 vehicle jump starter, also known as the Kap’SAM®. We recommend that you read this manual all the way through before using the device for the first time. It contains the information that will enable you to master and use the device on a day-to-day basis very quickly and efficiently.
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1. Description of the Kap’SAM® 2. Testing the Kap’SAM®’s state of charge 3. Starting a vehicle 4. Recharging the Kap’SAM® 5. Diagnosis and explanation of alerts displayed by the Kap’SAM® 6. Replacing the fuse 7. Warranty 8. Declaration of Conformity/EC Presentation of the device User interface... -
Page 3: Description Of The Kap'sam
1. Description of the Kap’SAM® The Kap’SAM® is a jump starter for vehicles with a flat battery. To To connect the Kap’SAM®’s clips to the vehicle, proceed as follows: avoid any malfunctions, it is indispensable to check the connection The battery terminal not connected to the chassis (usually the red polarities when attaching the Kap’SAM®... -
Page 4: Recharging The Kap'sam
Never make an attempt to start a vehicle lasting more than 15 seconds. If the broken down vehicle does not start after 2 attempts, the breakdown is due to something other than the battery. Look for the real cause of the breakdown before making any further attempts to start the vehicle. -
Page 5: Diagnosis And Explanation Of Alerts Displayed By The Kap'sam
5. Diagnosis and explanation of alerts displayed by the Kap’SAM® Indicators Polarities reversed. Connect the Kap’SAM®’s clips to the right polarities and begin the starting procedure again. The three state of charge indicators flash. Your Kap’SAM® is connected to a source with too high a voltage (e.g. -
Page 6: Warranty
Any addition or substitution of parts or Tél. +33 (0)4 77 922 584 accessories not made by SAM Outillage will invalidate the warranty. The E-mail : satminute@sam.eu warranty does not cover normal wear on parts (e.g.: cables, clips, etc.).