Charge The Drone; Lithium Battery Notes; Install Batteries In The Remote Control - Radio Shack Dominator 2.0 User Manual

Charge the Drone

1. Make sure the drone is turned off.
2. Connect the included USB charging cable to the drone's CHg jack and a
USB power source. The USB connector LED lights red during charging,
and turns off when charging is complete.
A full charge takes about 55-60 minutes, and provides up to 5 minutes
of flight time.
3. After charging, unplug the charging cable.
Caution
• Use only the included USB charging cable to charge the drone's battery.
Other cables may damage the drone.
• Always let the drone battery cool before recharging.

Lithium Battery Notes

Your drone uses a built-in lithium polymer battery for power. Follow the
instructions for charging.
• Do not charge longer than recommended. unplug the charging cable when
the drone is charged.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash with
soap and water. If in the eyes, rinse thoroughly with cool water. Immediately
seek medical attention.
• Do not attempt to charge or operate damaged toys.

Install Batteries in the Remote Control

1. Make sure the remote control is turned off.
2. Use a screwdriver to open the twin battery compartments. Then insert
four AAA batteries (not included), matching the polarities (+ and –)
marked inside. Replace the cover.
6001432_PM_En.indd 4
leD
4
CHg
on/ oFF
6/21/2016 12:04:21 PM