Invicta VR2 Installation Manuallines

Powered Wheelchairs
VR2 Attendant Control System
Installation Guidelines

GENERAL INFORMATION

The Attendant Control is an optional accessory that
may be factory fitted and supplied with the new
Invicta Powered Wheelchair, or can be installed as a
retro-fit accessory by following these instructions, in
conjunction with the attached
instructions from PG Drives Technology.
This Attendant Control, is intended for use, in
conjunction with the PG Drives Technology, VR2
JSM Remote Controller, fitted as standard to the
Invicta Powered Wheelchair.
NOTE: The installer is reminded of the importance
of keeping cable runs neat and as close to the
wheelchair as possible.
It is recommended that the User vacates the
wheelchair whist this accessory is being installed.
Although shown for right-hand use in these
instructions, the Attendant
installed onto the Invicta Powered Wheelchair, for
either left or right-hand operation.
Fig.2a
Backrest
Bracing
Tube
(b)
Fig.3a
In-line Cable Connector
IPC-S and IPC-T models
Controller can

INSTALLATION

Tools Required: 3mm and 5mm Hexagon Keys. Pair of Side-cutters or Scissors
 Install the Controller Stem Mount Fig.1, to the Backrest Bracing Tube
(Fig.2a) by removing the Tension Adjustable Backrest Cover, to gain all round
access to the Bracing Tube, (refer to page 18 of the User Manual).
and tighten at the required height by use of the black hand wheel (a) Fig.2a.
The Stem is fitted with a height adjustment stop collar (b) that should be
(c)
tightened in place against the Mount to ensure the Controller is refitted to the
same height following it's removal removed.
 With the Controller in the required position, fully tighten Stem Mount screws
sufficient to prevent any movement, before refitting the Tension Adjustable
Backrest Cover.
 Route the cable from the Controller downwards and attach to the Stem,
(a)
above the Mount, by cable tie (c) Fig.2a.
 Locate and separate, the grey in-line cable connector to the right of the Rear
Fig.3b
Fig.1
Attendant
Control with
Mounting
Stem
Plug (3)
be
Plug (1)
 Separate the end cap from the body of the Stem Mount
Fig.2b
(Fig.2b) and install Stem Mount onto Backrest Bracing Tube
as (Fig.2a).
Tighten just sufficient to maintain it's position at this stage.
 Insert the Attendant Controller Stem into the Stem Mount
(d)
(e)
Kit Components
Intermediate
Cable
Socket (1)
Battery Box, as shown in Figs.3a and
3b. Connect Plug 1 Fig.1 of the
Intermediate Cable, to Socket (d) Fig.3
and connect Plug (e) Fig.3 into Socket
1 Fig.1.
[PTO]
May 2012
Stem
Mount
Cable Ties
Alternative
Control
Knob
Socket (2)