Subscribe to Our Youtube Channel
Summary of Contents for Richdon Koi UltraSieve MIDI
- Page 1 ® ® Patent nr: NL 1026138 / EP 1593305 / US 2005/0258188-A1...
- Page 2 Introduction The MidiSieve is a pre-filter to filter waste solids from the water. This technique is based upon the sieve-bend. A sieve- bend consists of hundreds of sharp stainless steel profile wires with very small slot openings where the water can pass through but the solids remain on the sieve bend (see picture below).
-
Page 3: Pump Connection
UltraSieve Installation instructions Please read these instructions prior to installation. If you have any questions after reading this manual, please contact your UltraSieve dealer before you start installing to prevent mistakes. The UltraSieve can be installed in 2 ways: 1. Gravity (pond fed), equal to the water level in a direct connection with the bottom drain (and/or skimmer) 2. - Page 4 The auto-adjustable weir with float The UltraSieve has a floating system to prevent the water in the area under the sieve from rising above the level of the sieve for low speed pumps and also to prevent the water from going too low to be primed for high speed pumps. The floating device can be installed at 3 different levels.
- Page 5 Filling the floating device Fill the unit with 1 litre of water for counter weight and put the plug in the hole. Pump fed application When you want to use the UltraSieve above the water level with a submersible pump from the pond you must connect the pump hose to the 110mm inlet.
-
Page 6: Maintenance
Maintenance It is advisable to monitor the UltraSieve every day. Maintenance is very easy because of the waste outlet. In fact maintenance is about two operations: 1. To remove the waste that is on the surface of the sieve (every day). 2.
Need help?
Do you have a question about the UltraSieve MIDI and is the answer not in the manual?
Questions and answers