Power Supply - Tait T889 Manual

M889-00
6.2 Rack Wiring
Wire the D-range connector as shown in Figure 6.4. Ensure that the cables are not sub-
jected to any stresses due to tight bends or incorrect lengths.
The RF coaxial cables to the BNC and N-type connectors should be free from acute
bends or twists. If access to the rear of the rack frame is restricted, the cables should be
long enough to permit full withdrawal of the chassis from the guide.
Pin 9
+13.8V
Tx Key
Gnd
Pin 15
6.3

Power Supply

If a power supply other than an appropriate Tait model is used, ensure that it is capable
of providing enough current to drive the T800 system and is also free from excessive
ripple or noise.
Copyright TEL
Figure 6.4 D-Range Wiring - Rear View
Installation
Pin 1
Forward Power Alarm
Reverse Power Alarm
Forward Power Metering
Reverse Power Metering
Pin 8
6.5
02/10/95