Introduction to the product HOT-TOP is the IR-C heater environment for feeling good. It is perfect for restaurants, which surrounds you with his soft and cozy warmth. offices, supermarkets, factories and patios. HOT-TOP is perfect in focusing It emits no light on, but as the its warmth in defined areas indoor or outdoor.
Page 3
Benefits HOT-TOP means soft warmth resistances on duct have been volcanized with silicon in order and swaths your body making to make them lasting longer you feeling like closed to a chimney corner. and longer. Design, engineering HOT-TOP doesn’t dry the air production made in Italy.
Safety instructions Instructions should be carefully read before installation and retained by the user. The booklet must be keeped and delivered to the new user in case of cession of the machine. The Manufacturer reserves the right to vary the features of the product without prior notice. The technical data are merely indicative.
Page 5
Children should be supervised to ensure that they do not play with the appliance. Do not use in presence of gas, inflammable or explosive liquids or substances. Defined in BS5345. Some fundamental rules which apply to all electrical devices must be observed when using the heater: - Do not touch the heather with wet hands.
Electrical installation Warnings Before connecting the appliance make sure that the voltage is the same as indicated on the device and the line supply is corresponding to the effective rules. The installation should always be carried out by a qualified electrician or a competent person in accordance with the current electrical standards: HD 384 CENELEC for Mainland Europe, IEC 60446 and BS...
Circuit Fuse* breaker Active Neutral Earth * 10A (mod. 9815 - 9818) 16A (mod. 9824 - 9832) Additional information – Under no circumstances turn the appliance on if it is on any surface. A safety distance of not less than 100 cm should always be left in front of the heaters or too near.
Page 8
CAUTION! Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. Remote-controlled model Dimmer Module For maximum flexibility all - Insert into the remote models are available with control 2 batteries 1.5V dimmer to adjust the intensity AAA (not included),...
Page 9
select 1/3 of power: the blue LED lights HIGH POWER select max power: the red LED lights select 2/3 of power: the violet LED lights ignition device, which leads LOW power. shutdown device.
Page 10
Model and warmth diffusion 95mm 58mm 202mm 1,1m Small POWER 1500W RADIATE AREA 3150cm² RANGE 5 m² WEIGHT 5,7kg 1,25m 2,5m Medium POWER 1800W RADIATE AREA 3650cm² RANGE 7 m² WEIGHT 6,4kg...
Page 11
Temperature increase 1,55m Large POWER 2400W RADIATE AREA 4575cm² RANGE 9 m² WEIGHT 7,8kg 1,95m Extra Large POWER 3200W RADIATE AREA 5850cm² RANGE 12 m² WEIGHT 9,8kg...
Safety distances The heater must be installed at a minimum height of 180 cm. 30cm If installed in a toilet, the height should be 225 cm in zone 1 and zone 2; in zone 3 the minimum above ground level is 180 cm, according with the rules of each Country.
Page 13
The heater must not be directed towards the ceiling or flammable materials. The device must not be mounted into the ceiling. You must leave enough space around the top of the unit to ensure good ventilation. Do not use the heater in close proximity of a bath, shower or swimming pool.
Page 14
Provided wall/ceiling support cod. 004456 The support to be fixed to the wall presents a series of holes that allow to fix the heater in different positions.
Page 15
Optional supports Twin cod. 7704 End to end cod. 7705 Extension cod. 7706...
Page 16
Mounting Before being used, the heater must be fixed to the wall or to the ceiling by means of the provided supports. Drill four holes in the wall as shown below. 9,6cm * recommended value: Small 80cm* Medium 95cm* Large 125cm* Extra Large 180cm* Fix the two supports to the wall using dowels of...
Page 17
Insert the arch- shaped support in the special rail on the upper side of the device. Align the holes of the supports and join them together using the supplied bolts, setting the desired inclination. Ensure that the heater turns her rays in the area to be heated. Firmly tighten the screws when finished.
Care and cleaning Before cleaning, be sure the appliance is disconnected from the power supply and allowed to cool. Never immerse the appliance in water or any other liquid. To clean, use a soft damp cloth and then dry thoroughly. Make sure all parts are dry before using again.
Page 19
Disposal This product conforms to EU Directive 2002/96/EC. This appliance bears the symbol of the barred waste bin. This indicates that, at the end of its useful life, it must not be disposed of as domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment, or returned to a retailer on purchase of a replacement.
Page 20
Mo-El S.r.l. Via Galvani 18, 42027 Montecchio Emilia (RE) ITALY Tel.: +39 0522 868011 Fax: +39 0522 864223 info@mo-el.com www.mo-el.com Questo manuale è disponibile in formato digitale sul sito This manual is available in digital format on the website Ce manuel est disponible en format numérique sur le site Dieses Handbuch ist in digitaler Form auf der Website Este manual está...
Need help?
Do you have a question about the 9815 and is the answer not in the manual?
Questions and answers