Description Of Schematic Diagram - Sharp LC-32GD1E Service Manual

LC-32GD1E
LC-37GD1E

DESCRIPTION OF SCHEMATIC DIAGRAM

H
G
F
E
D
C
B
A
1
VOLTAGE MEASUREMENT CONDITION:
1. The voltage of each part is the value on operation of
the monitor only. It is measured using a 20 kΩ/V tester.
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
1. The unit of resistance "Ω" is omitted.
(K=kΩ=1000 Ω, M=MΩ).
2. All resistors are ± 5%, unless otherwise noted.
(J= ± 5%, F= ± 1%, D= ± 0.5%)
3. All resistors are Carbon type, unless otherwise noted.
: Solid
C W
: Oxide Film
S
: Metal Coating
N
CAPACITOR
1. All capacitors are mF, unless otherwise noted.
(P=pF=mmF).
2. All capacitors are Ceramic type, unless otherwise
noted.
(ML) : Mylar (TA) : Tantalum
(PF) : Polypro Film (ST) : Styrol
CAUTION:
This circuit diagram is original one, therefore there may be a
slight difference from yours.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH "å" (
FOR MAINTAINING THE SAFETY OF THE SET. BE SURE
TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR
MAINTAINING THE SAFETY AND PERFORMANCE OF
THE SET.
2 3
: Cement
: Special
T
)ARE IMPORTANT
4
36
5 6