Table of Contents
Advertisement
3. Install the daemon:
sudo yum -y localinstall
--disablerepo=* daemon-vca*rpm
4. Install the modules:
sudo yum -y localinstall
--disablerepo=* vcass-modules*rpm
5. Update boot to the new kernel:
sudo grub2-set-default 0
6. Reboot system:
– Boot image:
metal_XXX.img
– Check status:
Note: Repeat until the status shows
net_device_ready for all nodes.
7. Verify connection to one node:
a. For software package 1.0, use:
ssh root@172.31.1.1
b. For Software Package 1.2 or later, 'If
bridging is enabled, IP address may be
defined by DHCP server instead of the
configuration file
Note: Password =
change the third octet in the IP address.
The booted image is not persistent by default.
Refer to the user guide for instructions on how
to make changes persistent across boots.
sudo reboot
vcactl boot vca_bare-
vcactl status
vista1
14
. For other nodes,
Advertisement
Table of Contents
