Interflex IF-80x Manual

95-10330 V2017-07-24
IF-80x Outdoor Slave Terminal
Thank you for choosing a product from Interflex. With this product, you have purchased a reliable device for
access control.
1.1 Scope of delivery
IF-80x Outdoor terminal (slave)

I/O controller board for controlling locking devices

Material for fastening

8-pin terminal strip

Blue wire for grounding the back panel

Mortise lock

Plastic strips for sealing the mortise lock

Adhesive tape for mounting the I/O controller board

Please check the completeness and condition of the
shipment upon receipt.
1.2 CE conformity
The device complies with the requirements of the respective EU guidelines (CE conformity).
Modifications to the device are not permitted.
All information contained in this documentation is accurate at the time of printing. All specifications are
subject to change without notice.
The product brand names and trademarks specified in this documentation are protected by commercial and
patent laws.
1.3 Shielded cables
To ensure malfunction-free operation, we recommend the use of shielded bus cables.
Operation is also possible with unshielded cables. In case of transmission problems, you will have to
examine the reasons in each individual case. Where necessary, a shielded cable should be used for the
connection of the respective devices.
1.4 Intended use
The device is used for reading RFID credentials, e.g. in access control systems, and also for controlling
locking devices. Any other use is not in accordance with the intended purpose and is therefore not permitted.
1.5 Function
Slave terminals of series IF-80x Outdoor are used for:
controlling the access of people who identify themselves via an RFID credential before entering a

security zone.
controlling and monitoring locking devices that prevent uncontrolled (physical) access to security zones.

writing NetworkOnCard access rights. The data is used for identification at offline devices, e.g. electronic

door fittings.
Interflex Datensysteme GmbH 1/13