Parksense Rear Park Assist - Dodge Challenger 2017 User Manual

O P E R A T I N G Y O U R V E H I C L E
Near
Changing the FCW status to the "Near" setting, allows the system to warn you of a
potential frontal collision when you are much closer.
This setting provides less reaction time than the "Far" setting, which allows for a more
dynamic driving experience.
More dynamic or aggressive drivers that want to avoid frequent warnings may prefer this
setting.
Refer to your Owner's Manual on www.dodge.com/en/owners/manuals for further details.
Forward Collision Warning (FCW) is not intended to avoid a collision on its own, nor can
FCW detect every type of potential collision. The driver has the responsibility to avoid
a collision by controlling the vehicle via braking and steering. Failure to follow this
warning could lead to serious injury or death.

PARKSENSE REAR PARK ASSIST

The ParkSense Park Assist system provides visual and audible indications of the distance
between the rear bumper and a detected obstacle when backing up, e.g. during a parking
maneuver.
ParkSense can be enabled and disabled with the ParkSense switch, located on the switch
panel below the Uconnect display.
NOTE:
ParkSense will retain the last system state (enabled or disabled) from the last ignition
cycle when the ignition is changed to the ON/RUN position.
ParkSense can be active only when the gear selector is in REVERSE. If ParkSense is
enabled at this gear selector position, the system will remain active until the vehicle speed
is increased to approximately 7 mph (11 km/h) or above. The system will become active
again if the vehicle speed is decreased to speeds less than approximately 6 mph (9 km/h).
The four ParkSense sensors, located in the rear fascia/bumper, monitor the area behind
the vehicle that is within the sensors' field of view.
NOTE:
• The sensors can detect obstacles from approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear bumper while the vehicle is in REVERSE, a warning
will display in the instrument cluster display only when "Sound and Display" is
selected from the Uconnect System.
• As the vehicle moves closer to the obstacle, the instrument cluster display will show
fewer arcs and the sound tone will change from slow, to fast, to continuous.
Refer to your Owner's Manual on www.dodge.com/en/owners/manuals for further details.
WARNING!
75