Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Turbo incanto
Summary of Contents for Turbo incanto
- Page 1 INSTALLATION AND USER’S MANUAL...
-
Page 2: Table Of Contents
Contents INTRODUCTION ..............3 SAFETY PRECAUTION ............. 3 Electrical Shock Hazard ............ 3 WALL MOUNTING INSTALLATION ........4 Prepare for installation ............ 4 Installation (Vent outside) ..........5 Installation (Vent inside) ..........8 ISLAND MODEL INSTALLATION ........9 SLIM MODEL INSTALLATION ......... 11 OPERATION .............. -
Page 3: Introduction
INTRODUCTION Thank you for choosing this cooker hood. This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safely, please read this instruction manual carefully before installation and usage. -
Page 4: Wall Mounting Installation
WALL MOUNTING INSTALLATION Prepare for installation a. If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or inflammable material with an interior diameter of 150mm) b. -
Page 5: Installation (Vent Outside)
Installation (Vent outside) Attention! Observe the warning in the instruction sheet concerning the operation of the appliance when air is discharged from the room. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards When the range hood and appliance supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must be not exceed 4 Pa (4×10... - Page 6 Chimney installation. For Glass model and T shape model Put the upper chimney into the lower chimney. Then pull the upper chimney upwards. Adjust to reach the height required. Slide the chimney to adjust the chimney height. When the height you require is reached, hang the fixing hole to the fixing screws as showed in below pictures.
- Page 7 For Tower model Put the inner chimney into upper chimney. Then pull the upper chimney upwards. Adjust to reach the height required. Fix the lower chimney with 2 pcs of 4x8mm screws. Slide the chimney to adjust the chimney height. When the height you require is reached, fix 2 pcs of 4x8mm screws onto the hole fixing with plate I as showed in below pictures.
-
Page 8: Installation (Vent Inside)
Installation (Vent inside) If you do not have an outlet to the outside, exhaust pipe is not required and the installation is similar to the one show in section “Installation (Vent outside)”. Activated carbon filter can be used to trap odors. In order to install the activated carbon filter, the grease filter should be detached first. -
Page 9: Island Model Installation
ISLAND MODEL INSTALLATION 1) Position the hanging plate on the ceiling and then mark the position of the screw holes. The hanging plate should be securely fixed to the ceiling, 11 x ST6 (40 mm) screws for wooden ceiling ... - Page 10 5) If the glass canopy has not been pre-assembled by the factory, then it should be fixed to the top of the main body of the cooker hood at this stage. 6) Lift the main body of the cooker hood onto the angle bar and then fix it into position using the 16 x M5 screws.
-
Page 11: Slim Model Installation
SLIM MODEL INSTALLATION Method one: To install onto the wall drill 2 holes of Ø8mm on a suitable place according to the centre distance of hole at the back of the cooker hood. Insert the nut into the holes. ... - Page 12 Method two: Drill 4 holes of 6mm diameter at the bottom of the hanging cupboard Put the one-way valve on the cooker hood, then install the cooker hood on the bottom of the hanging cupboard, tighten the hood with enclosed 4 screws. Note: 1.The extensible pipe are optional accessory and are not supplied.
- Page 13 Air ventilation setting Outdoor exhausting: Turn the adjuster to outdoor position, install the outlet, turn on the cooker hood, then the air will be vented from the outside outlet. Recycling: the recycling mode with carbon filter,Turn the adjuster to indoor position, install the outlet cover, turn on the cooker hood, then the air can be vented from the inside outlet.
-
Page 14: Operation
OPERATION Push button/Electronic button 1 0 Off button It’s used for turning off the fan. Low Speed button It’s used for ventilation in the kitchen. Suitable for simmering and cooking which do not give out too much steam. Medium Speed button Airflow speed is for ventilation in standard cooking operation. - Page 15 Touch control 1 LCD display 1.Fan symbol, will turn when the fan is working 2.Time display 3.Timer 4.Light 5.Fan speed 6.Alarm symbol 7.Cleaning symbol, appear when total working time up to 14 hours.
- Page 16 Touch control 2（Booster Model） After plug in power supply, it will go into Stand-By mode automatically. Timer button To set time, keep pressing it while on stand-by mode until the hour display starts to flash. Now press" "or" " to set the hour. Once confirmed, press" "...
-
Page 17: Maintenance
MAINTENANCE Before cleaning, switch off the unit and pull out the plug. I. Regular Cleaning Use a soft cloth moistened with hand-warm mildly soapy water or household cleaning detergent. Never use metal pads, chemical, abrasive material or stiff brush to clean the unit. II. - Page 18 Halogen lamp (max, 20W) & LED lamp (max,1.5W). For Slim model.
-
Page 19: Trobuleshooting
TROBULESHOOTING Fault Cause Solution The fan blade is jammed. Switch off the unit and repair by Light on, but fan qualified service personnel only. does not work The motor is damaged. light bulb burn. Replace the bulb with correct rating. Both light and fan do not work Power cord loose... -
Page 20: Environmental Protection
ENVIRONMENTAL PROTECTION Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Need help?
Do you have a question about the incanto and is the answer not in the manual?
Questions and answers
Use outdoor mode or use indoor mode?
Use outdoor mode if you want to vent air outside. Turn the adjuster to the outdoor position, install the outlet, and turn on the cooker hood.
Use indoor mode (recycling) if outdoor venting is not possible. Turn the adjuster to the indoor position, install the outlet cover, and ensure a carbon filter is used. Replace the carbon filter every three months or after 120 hours of use. Do not wash or expose the filter to heat.
This answer is automatically generated